Page 1
Pan Acoustics reserves the right to modify products without prior notice. www.pan-acoustics.de SINCE 2002 Pan Acoustics GmbH │ Schweigerstr. 13d │ D-38302 Wolfenbüttel │ Germany │ Tel.: +49 (0) 5331 900 95 70 │ E-Mail: contact@pan-acoustics.de Page 1 of 14...
Page 2
If the product is resold, the document must be handed over to the new owner in printed or electronic form. Pan Acoustics reserves the right to change / update the document without prior notice. The latest version of this document can be downloaded from the Pan Acoustics website.
1. Introduction Thank you for choosing a Pan Acoustics product. With the purchase of the DANTE INTERFACE - PAN NET, you have acquired an accessory for Pan Acoustics active loudspeakers. With this interface you can integrate loudspeakers with AES/EBU interface into an already existing Dante network. An external power supply unit is required to ope- rate the interface.
The original packaging should be used when transporting the device. The device is to be protected against vibrations. 2.1. Safety instructions All products from Pan Acoustics are developed and manufactured in Germany according to the latest safety regulations. Each product is thoroughly inspected prior to shipping according to in-house quality guidelines.
Software for setting up and monitoring the Dante audio network 5. Product description The DANTE INTERFACE - PAN NET is an audio network bridge for integrating Pan Beam speakers with an AES/EBU input into a Dante audio network. The Pan Beam speakers can be confi gured and monitored from a PC with installed “Pan Beam Setup”...
20..36 VDC / 0,5 A WARNING The Pan Net Link port is not allowed to be connected to Ethernet devices such as switches, routers and network cards of PCs or laptops. Operation of these devices can lead to malfunctions and defects on these units and on the Pan Net Link port.
Manual 6.2. Pan Net Link connection (1) COM Red LED lights up during data transfer 6.3. Pan Net RJ45 pinout (DANTE INTERFACE) Description unassigned unassigned unassigned Input B + (AES/EBU) Input B - (AES/EBU) unassigned RS485 + RS485 - Enclosure PE (earth / ground) Shield 6.4.
Manual 7. Dante 7.1. Setup The active speakers with AES/EBU interface from Pan Acoustics are to be set up via the „Pan Beam Setup“ software. The Dante Controller software from Audinate must be installed for access to a Dante net- work.
“switched” and“redundant” modes in the Dante network. Switched: If the DANTE INTERFACE - PAN NET is set to “switched”, an additional Dante device can be connected on the secondary port, e.g. a stage box, and operated in the Dante network.
11. EC conformity (CE mark) The declaration of conformity for the relevant product from the Pan Beam series can be re- quested from Pan Acoustics. 12. WEEE declaration (disposal) The waste bin symbol points out that electrical and electronic components are not al- lowed to be disposed of in household waste.
15. Technical data ELECTRICAL PROPERTIES Network I/O: 1 x etherCON Primary 1 x etherCON Secondary 1 x etherCON Pan Net Link Audio input via Dante: 44.1 / 48 / 96 Sample rate Supported Dante network modes: Switch / redundancy mode...