Akit-BASIC Stamp2SX
BASIC Stamp2SX / i-Stamp microcontroller Activity Kit
1. Kit Contents
In standard package of Akit-BASIC Stamp2SX include :
1. i-Stamp board
2. AX-2SX activity board
3. CX-232 serial port cable
4. SLCD16x2 Serial LCD module
5. Uni-polar stepper motor
6. Documentation
7. CD-ROM
To run this activity kit you'll need : DC adaptor +9Vdc 500mA or higher
(maximum +16Vdc)
2. Kit features
2.1 i-Stamp microcontroller board
l Work abilities are compttiable with BASIC Stamp 2SX module (BS2SX-IC)
l 50 MHz clock frequency . Operate up to 10,000 P-BASIC command/second
l 16KByte memory, separate 8 sections, 2KByte/each, erasable 100,000+ times
l 32 byte RAM with 64 byte Scratchpad RAM
l Consumption 65mA in full operation and 200mA in sleep mode
l Connecting to PC's serial port for programming and debuging
l 16 I/O, freedom separeted work or set in groups from 4, 8 and 16 pins
l 30mA/30mA source/sink current. Maximum 60mA/60mA source/sink current per
8-pins groups (P0-P7/P8-P15)
l I/O pin can drive LED (with current limit resistor) and 6V servo motor directly
l LED power status
l Board sizes 1.7" x 1.2"
l Develop with BASIC Stamp Editor program
Akit-BASIC Stamp2SX : BASIC Stamp2SX Activity kit l 1
x 1
x 1
x 1
x 1
x 1
x 1
x 1