Page 3
Introductie De EazyLAN is een testtool geschikt voor het snel en eenvoudig testen van de doorgang van een RJ45 kabel/ aansluiting. Let op: Sluit de EazyLAN niet aan op circuits welke in gebruik zijn, dit kan schade aan de meter...
• Plaats het batterijklepje terug aan de achterzijde van de EazyLAN Service De EazyLAN bevat geen onderdelen die door de eigenaar zelf kunnen worden vervangen. Reparaties mogen alle worden uitgevoerd door Mors Smitt. Garantie Mors Smitt B.V. geeft gedurende een periode van 12 maanden garantie op de EazyLan.
Page 6
EazyLAN Selecteer ‘Step’ aan de onderzijde van de EazyLAN Druk op de testknop, de EazyLAN meet de doorgang van de eerste ader Bij elke volgende druk op de testknop wordt de volgende...
Page 7
Indien er een open verbinding wordt gemeten, zijn aan het eind van de test de LEDs van de foutieve aders niet opgelicht. De Fail en Open LED lichten op en er klinkt 1x een pieptoon. RJ45 UTP 1 & 2 open RJ45 STP 1 & 2 open www.nieaf-smitt.com...
Page 8
Indien er een gekruist circuit wordt gemeten, zijn aan het eind van de test de LEDs van de foutieve aders niet opgelicht. De Fail en Cross Led lichten op en er klinkt 2x een pieptoon. RJ45 UTP 4 & 8 cross RJ45 STP 4 & 8 cross www.nieaf-smitt.com...
Page 10
RJ45 cables. It is ideal for testing the continuity of each pin of a LAN cable prior to installation on equipment. Caution: Do not attach the EazyLAN to a live circuit. This might cause permanent damage to the device. Description of the device •...
LED is visible and the battery needs to be replaced. Instructions (first use) • Open the battery cover on the back of the EazyLAN and install the 9 V battery • Replace the battery cover...
Page 13
Select ‘Autotest’ function at the bottom of the EazyLAN Push the testbutton, the EazyLAN will automatically check all pins When all pins are checked, the EazyLAN will indicate a PASS or FAIL: When the cable is correct: - the green ‘Pass’ LED illuminates...
Page 14
Pass When all pins are correct, the pin LEDs are illuminated. The Pass LED illuminates and the EazyLAN will beep 3 times. RJ45 UTP pass RJ45 STP pass Open At the end of the check the Open circuit pins are not illuminated, the Fail and Open LED are illuminated and the EazyLAN will beep 1 time.
Page 15
RJ45 STP 1 & 2 short Cross At the end of the check the Cross circuit pins are not illumina- ted, the Fail and Cross LED are illuminated and the EazyLAN will beep 2 times. RJ45 UTP 4 & 8 cross RJ45 STP 4 &...
Page 16
18-10-2022 Wabtec Netherlands B.V. Darwinstraat 10 6718 XR Ede T +31 (0)88 600 4500 E wnl_salessupport@wabtec.com I www.nieaf-smitt.com Nieaf-Smitt is a brand name of Wabtec Helpdesk: T +31 (0)88 600 4555 NETH ERLA ND S E wnl_helpdesk@wabtec.com I www.morssmitt.nl/support (c) Copyright 2022 All rights reserved.