Table of Contents
Advertisement
4. SELECTING THE ADJUSTING ITEMS
1)Every pressing of CHANNEL
(
button for reverse order)
Refer to table-2 for preset data of adjustment mode.
(See SETTING & ADJUSTING DATA on page 27)
5. ADJUSTING THE DATA
1) Pressing of VOLUME
depends on the adjusting item.
6. EXIT FROM SERVICE MODE
1) Pressing POWER button to turn off the TV once.
INITIALIZATION OF MEMORY DATA OF QA02
After replacing QA02, the following initialization is required.
1. Enter the service mode, then select any register item.
2. Press and hold the CALL button on the Remote, then press the CHANNEL
been complated.
3. Check the picture carefully. If necessary, adjust any adjustment item above.
Perform "Auto tune" on the owner's manual.
CAUTION: Never attempt to initialize the data unless QA02 has been replaced.
7. TEST SIGNAL SELECTION
1) Every pressing of
in SERVICE MODE.
Signal off
ALL Red
All manuals and user guides at all-guides.com
button in the service mode changes the adjustment items in the order of table-2.
+/– button will change the value of data in the range from 00H to FFH. The variable range
button on the Remote Control changes the built-in test patterns on screen as described below
ALL Green
button on the TV. The initialization of QA02 has
ALL Blue
ALL Black
• All White
• All Red
• All Green
• All Blue
• All Black
- 5 -
ALL White
Signals
Picture
Advertisement
Table of Contents
