Fumex ASEM Installation

Installation
- The box shall be mounted with the cables entering and exiting
from the bottom of the box.
- The box shall not be mounted in a metal casing.
- All metal objects in the vicinity of the receiver will impair the
reception.
- The antenna is built-in.
- Minimum distance: Between floor/ground and receiver 150 cm.
Between two receivers
Mellan sändare och mottagare
Cable drawing
1 2
1: EKK 3 G 1,5 mm² 2: EKK 4 G 1,5 mm²
Wire diagram
Receiver box
Centralis receiver RTS
L1
N
N.B.! Only one motor must be connected to the Centralis box!
20 cm.
30 cm.
Feeding live Not in use
L L
Feeding neutral Not in use
N N
N Motor neutral
Motor up
N N L N L
Motor down
Blue
Black
Motor
Brown
Yellow-Green
Programming of transmitter and receiver.
Open the lid of the receiver box.
Receiver box:
Press the programming button, B, inside the receiver box approximately
2 seconds, until the indication lamp, A, starts to shine.
The receiver is now, during one minute, ready to receive the signals from
the transmitter.
Transmitter:
Press shortly the programming button of the transmitter, G.
The indication lamp in the receiver box then starts to twinkle, which shows
that the transmitter's signal is memorised and programmed.
Delete programming.
Open the lid of the receiver box.
Receiver box:
Press the programming button, B, inside the receiver box approximately
10 seconds until the indication lamp, A, starts to shine.
Receiver box
A Indication lamp
B Programming button
C Push button for
manual testing
Transmitter
1
D Up
E Stop
F Down
G Programming button