Table of Contents Change Loom Name Change or Set Wireless Network Change from LoomDirect to WiFi/Router Change from WiFi/Router to LoomDirect Close AVLDrive Connect to AVLDrive Connect via LoomDirect Connect via USB cable Connect via WiFi/Router IP addresses LED Lights on the CD5 Power On/Off the CD5 Standby &...
Change Loom Name 1. AVLDrive Options tab 2. Type in a name in the ‘Loom Name’ field 3. Press Enter on keyboard, or click outside the ‘Loom Name’ field if using a tablet. Change or Set Wireless Network Changing Network settings is done in the ‘Network’ tab in AVLDrive. If unable to connect wirelessly to change settings, connect using the USB cable.
Connect via USB cable 1. Connect the supplied USB cable to the CD5 and your computer/device. 2. Open a browser on your computer/device. 3. Enter the correct USB IP address for your computer (Mac/Windows). Connect via WiFi/Router 1. Connect your computer/device to the same WiFi network as your CD5 2.
Power On/Off the CD5 Power On: 1. Plug the power cord into the wall outlet or power supply 2. Wait for the CD5 LEDs to stabilize (Power: yellow, Network: red/green, all others are off) 3. Ready to connect to AVLDrive Power Off: 1.
http://192.168.7.2/showlog or Show the CD5 Log http://NewLoom.local/showlog http://192.168.7.2:8080/showConfig or Show the CD5 Configuration file http://NewLoom.local:8080/showConfig http://192.168.7.2/loomState or Show the current state of the loom/CD5 http://NewLoom.local/loomState Supervisor commands are intended for troubleshooting and/or when trying to return the CD5 to a normal operating state. These commands are typed into the address bar of the browser. NOTE: if typing a command into the address bar of a browser tab that has AVLDrive open, the AVLDrive session will end.
WIF files - upload, delete, rename Upload a file to AVLDrive 1. Go to the Files tab in AVLDrive 2. Click ‘Upload to Loom’ 3. Select the desired WIF file from your computer/device Delete a file from AVLDrive 1. Go to the Files tab in AVLDrive 2.