Advertisement
REAR PANEL
1. AC Mains connector
2. DC OUTPUTS, right and left channel, for JRDG Corus
Preamplifier
3. AUXILIARY OUTPUTS, JRDG Aeris DAC and/or Conductor Phono
Stage
4. 12V REMOTE INPUT, 3.5 mm connector, for remote On operation.
5 volt to 12 volt DC required to turn PSU ON.
NOTE: There is no advantage gained by using after market power cords to power
the PSU. There will be no sonic improvement. Use of some after-market power
cords with non-standard connectors can disconnect power intermittently
resulting in loss of power to the PSU with the result of anomalous operating
conditions. Our advise is to use the supplied power cord.
Output noise
< 3 microvolts wideband
PAGE 10
Advertisement
