Advertisement
I NSTA LLAT ION GU IDE
This p rod u c t m us t be ins t a l l e d b y a l i cen sed p lu mb e r.
I N STAL L AT I O N GUI DE
This i s a ge ne ral i ns t al l a t i o n g u id e - th ere a re ma ny fa ct o r s
Note: This product must be installed by a licensed tradesperson.
tha t a re i nvol ve d t hat c a n a l t er th e i nst a ll a ti on met ho d .
This p rod u c t i ns t al l mu st c om pl y wi th A S / N ZS 3 50 0.
This is a general installation guide - there are many factors that are
involved that can alter the installation method.
Check the desired height of basin from floor.
1
Hold basin against wall aligning outlet of trap with waste pipe.
3
Extend telescopic trap up or down to find desired height &
cut waste to suit trap.
Secure plumbing to basin and wall outlet. Test by running
5
water through the waste. Place the cover plate over drain.
Silicon top and sides of basin if necessary.
Reg ular ly clean with
mild liq uid deterg en t
or s oap a nd wate r.
Fit wastes and traps to basin .
2
If correct height and position is suitable, level the top of
4
the basin & mark out desired position.
Drill holes through the back of basin into structure within
wall with a wood drill bit at maximum 450mm centres.
Fix basin into structural support in wall. ABI takes no
responsibility if vanity is not fixed into wall structure.
8 x Wall plug
8 x Hanger bolt
8 x Plastic washer
D O N OT us e c re am
c le a ner s o r b leac h.
The se s ub s t anc es a re
ab ras ive.
.
8 x Metal washer
8 x Nut
1 x Basin
D O NOT u se c l ea n i ng
p ads wi th a b ra si ve
s ur fac es as thi s m a y
s cra tch th e m a ter i a l .
Advertisement
