All rights are reserved. No part of this manual may be photocopied, reproduced or translated to another language without prior written permission of Microtek International. Microtek International Inc. No. 6, Industrial East Road 3, SBIP...
Important Notice This device complies with FCC Rules Part 15. Operation is subject to the following two conditions: (1) This device may not cause harmful interference and (2) this device must accept any interference that may be received, including interference that may cause undesired operation. Safety Instructions (1) This DVD player is a portable, class I-laser product.
3.5 inch TFT-LCD Panel with 4:3 aspect ratio Built-in top-loading DVD player 36-key Infrared Remote Control 11 Control Buttons on the Front Panel: PLAY, STOP, NEXT, PREV, MENU, SELECT, PIX, UP/DOWN, RIGHT/LEFT A/V Output Jacks Stereo Headphone Jack DC Power Input Jack Volume Control with Rotary Potentiometer Battery LED Indicator RED: Battery Charging...
Page 5
Table of Contents 0 1 . C o n t r o l B u t t o n s o n F r o n t P a n e l ......0 4 0 2 .
Description of Functions 1. PLAY Press this button to play or pause DVD playing. 2. STOP Press this button to stop DVD playing. STOP -> STOP -> PLAY: Play disc from the beginning STOP -> PLAY: Resume from the point where playing stopped.
Page 8
9. IR Sensor - Forward Sensor Eye Allow remote controller to navigate the OSD (On Screen Display) on this unit and to control other accessories. 10. LCD Panel...
Right Side: I/O Ports on the Sides 11. POWER Slide Switch 12. HOLD Slide Switch 13. DC INPUT ON: System power on STANDBY: Turn off LCD backlight. OFF: System power off ON: Disable system responses to the control buttons on the front panel. OFF: Enable system responses to the control buttons on the front panel.
Left Side: 14. VOLUME Control Use rotary potentiometer to adjust audio volume. Clockwise: Increase volume Counterclockwise: Decrease volume 15. Stereo Headphone Jack Accommodate headphones for monitoring audio. 16. VIDEO-OUT-AUDIO (1) Video jack: CVBS signal (2) Audio jack: Stereo audio signal...
Front Side: Rear Side: 17. OPEN Switch (Door Locker) Slide towards the right to open the front cover. 18. POWER LED : Power on Blinking in RED: Battery low 19. CHARGE LED : Battery charging GREEN : Battery full 20, 21. VISOR Holes Slots to accommodate hooks for the sun visor.
RADIATION EXPOSURE. TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER. NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. Microtek International Inc. No. 6, Industrial East Road 3, SBIP Hsinchu, Taiwan Manufactured: April, 2004 THIS PRODUCT COMPLIES WITH FDA RADIATION PERFORMANCE STANDARDS, 21CFR SUBCHAPTER J.
Battery Battery Housing BATTERY INSTALLATION Before attempting to operate your remote control, install the batteries as described below. (1) Turn the remote control face down. Press down on the ridged area of the battery cover and slide it off. (2) Slide another battery in. The remote control will operate the unit.
Page 14
Description of Functions 1. Setup Navigate the SETUP MENU. There are 4 pages to configure the system: (1) Language Settings (2) Graphic Settings (3) Audio Settings (4) Favorite Settings 2. Menu Go to the Root Menu included in the disc. 3.
Page 15
13. PLAY/PAUSE 14. STOP Stop playing the movie or songs. 15. PREV Play the previous chapter or track. 16. NEXT Play the next chapter or track. 17. FF (Fast Forward) 18. FR (Fast Rewind) 19. Slow -13- Press this button to play or pause a movie while disc is loaded into the disc compartment.
Page 16
20. REPEAT (Except VCD with PBC on) Repeat part or all of a chapter, title, track, or an entire disc. 21. A- B (Except MP3) Repeat from point A to point B. 22. Title Navigate the Title Menu included in the disc. 23.
Supplying the AC Power to the Unit AC Plug 1. Insert the DC plug into the "DC INPUT" jack on the right side of the unit. 2. Attach the AC plug to the AC outlet. General Operating Instructions DC Plug -15- Turning the unit ON or OFF 1.
Charging the Battery Pack Battery Pack CHARGE LED POWER Switch POWER LED When the "POWER LED" starts to blink in red, the battery will stop supplying power to the system in 10 minutes. At this time, the user needs to charge the battery.
Unloading the Battery Step 1: Press the points on the battery pack with your fingers, as indicated by the diagram above. Step 2: Keep pressing and pull the battery pack out in the direction indicated by the drawing above. -17- Step 3: Slide the battery pack out, as shown in the diagram above.
To get the optimum use out of your DVD player, make sure you read this section completely. Regional Coding Both the DVD player and disc are coded by regions. These regional codes must match in order for the disc to play. If the codes don't match , the disc won't play.
Page 21
Settings and Adjustments This chapter describes how to use the on-screen setup pages included in the SETUP MENU. Using the Setup Menu Using the setup display, you can do the initial setup, adjust the picture quality, and set the various outputs. You can also set a language for the on-screen display and the setup display, as well as limit playback by children.
Settings for Display Press the SETUP button, use the to navigate to the Graphic Settings icon, and then use the button to select the Graphic Type submenu. The setup allows you to adjust the aspect ratio of the screen. Press and then use the buttons to select the appropriate setting.
Default Settings Press the SETUP button, and use the "left/right" buttons and the "down" button to go to the Default Setting submenu under the Favorite Setting icon. The default setup allows you to reset all options to factory defaults. Press and then press SELECT to reset.
Parental Settings (Parental Control) This section of the SETUP MENU allows users to rate the contents of a movie during playback, from G to ADULT. The parental control function allows you to limit viewing choices for children and other minors. 1.
Page 25
Settings for Password (Parental Control Password) Press the SETUP button and navigate to the Password submemu under the Favorite Setting icon. The menu appears and allows you to change the parental control password. Press and then press SELECT. OLD PASSWORD Input the old password or the default password (4 digits).
When playing an audio CD, the DISPLAY banner appears automatically. It displays the current track and the amount of the time for that track playing , the total amount of time on the disc and the current time running on the disc. Press the DISPLAY button on the remote to display the DISPLAY banner.
MP3 is the format for storing digital audio. An audio CD-quality song can be compressed into the MP3 format with very little loss of quality, while taking up much less space. CD-R/RW discs that have been encoded in MP3 format can be played on your DVD player.
Skipping Songs Use NEXT button ( ) on the remote control to move to the next song. Use the PREV button ( ) to move to the beginning of the currently playing song. Press the times to move to the previous song. Using the REPEAT Feature The default mode for the Repeat feature is OFF.
Warnings Do not use any solvents or cleaning materials when cleaning the video system. Do not use any abrasive cleaners, as these may scratch the screen. Use only a lightly damp- ened lint-free cloth to wipe the screen if it is dirty. Before putting on headphones always adjust the volume setting to the lowest position.
Need help?
Do you have a question about the FunView S350 and is the answer not in the manual?
Questions and answers