Related Manuals for Faber BELLUS HEROS 100
Summary of Contents for Faber BELLUS HEROS 100
- Page 1 BELLUS HEROS 100 wood stove installation manual and instructions for use Saturnus 8 NL-8448 CC Heerenveen Postbus 219 NL-8440 AE Heerenveen...
-
Page 2: Table Of Contents
DESCRIPTION OF THE STOVE TABLE OF CONTENTS 1. FOREWORD 2. INTRODUCTION 3. SAFETY PRECAUTIONS 4. INSTALLATION 4.1 Installation Instructions 4.2 Installation Space 4.3 Location and Minimum Free Space 4.4 Chimney 4.5 Connecting the Stove 5. USING THE STOVE 5.1 Fuel 5.2 Filling Capacity 5.3 Lighting the Stove 5.4 Flame Regulation... -
Page 3: Introduction
As you read this manual, you will quickly learn how to operate You can heat any room with your new Faber International wood your stove. You will also find information on the safety and the stove. The only condition is that you have the correct chimney maintenance of the appliance. -
Page 4: Safety Precautions
3. SAFETY PRECAUTIONS 4. INSTALLATION 4.1 INSTALLATION INSTRUCTIONS - Have the stove installed by a qualified installer in accordance with local and national (fire safety) regulations. Have the stove installed by a qualified installer in accordance - Have the chimney cleaned before each heating season. with national and local (fire safety) regulations. -
Page 5: Chimney
The distance between the stove and wooden or synthetic We recommend the following interior dimensions for smooth, furniture must be at least 30 cm. well-insulated chimneys with an effective height of 5 to 15 metres: In the event of installation on floors that are not heat-resistant, or heat-sensitive subfloors in particular, the stove should be Maximum Minimum... - Page 6 RIGHT WRONG Chimney Opening: - Chimney operation should not be hindered by the roof. Reduced diameter due to - In the event of a roof slope of 23° or less, the chimney- the pipe being inserted opening should extend 0.5 metre above the roof surface. too far.
-
Page 7: Connecting The Stove
5. USING THE STOVE 4.5 CONNECTING THE WOOD STOVE The stove comes equipped with an exhaust pipe connection on 5.1 FUEL the top. If the stovepipe is to be connected to the rear of the stove, This wood stove is designed to burn: then the stovepipe collar should first be removed. -
Page 8: Lighting The Stove
5.3 LIGHTING THE STOVE 5.4 FLAME REGULATION Make sure that all packaging, including paper and lining, has been To ensure adequate combustion, both vents should be closed removed. about 1/3 of the way (secondary air supply only). The intensity of the fire can be regulated by closing the vents further. Ensure that the chimney operates properly. -
Page 9: Cleaning And Maintenance
6. CLEANING AND MAINTENANCE Then treat the glass with a preservative for Ceramic plates (Cera-fix). This applies an invisible film to the window, which Warning makes it easier to clean. Do not clean the stove until it has completely cooled. We recommend treating the windows regularly with such a preservative. -
Page 10: Troubleshooting
7. TROUBLESHOOTING PROBLEM C C A A U U S S E E REMEDY P P R R O O B B L L E E M M C C A A U U S S E E R R E E M M E E D D Y Y Stove causes a smell. -
Page 11: Appendix 1
APPENDIX 1 PARTS LIST GB 18 GB 19... - Page 12 APPENDIX 2 T T E E C C H H N N I I C C A A L L D D A A T T A A T T E E C C H H N N I I C C A A L L D D A A T T A A B B E E L L L L U U S S H H E E R R O O S S 1 1 0 0 0 0 VHR registration number...