Table of Contents
Advertisement
11. INSTALLATION - ANGLED HOUSING
STEP 1. Choose a suitable location for the
shower to be installed. The unique
�������������������
�������������������
surface.
Note Maximum curvature = 1 m (3ft 3") radius.
������������������
allow for the handset and hose when
stowed. (See Fig. 7).Ensure that the
plumbing connections and p clamp are
mounted as close as possible to the
handset housing to ensure maximum
usable hose length.
Please note:�������������������������������������
hose when stowed. Also ensure that it is free from obstructions when pulled out.
STEP 2, Drill one 89mm (3 1/2") diameter circular
���������������������
water line).
Minimum bulkhead thickness = 6mm (1/4")
Maximum bulkhead thickness = 12mm (1/2")
(See Fig. 8)
STEP 3. T������������������������������������
should be loosened until almost disengaged from the threaded part.
STEP 4. Ensure the black coloured support ring is in place behind the housing. If the
housing is to be placed on a curved surface replace this with the appropriate
support ring as outlined below:
On a Flat Surface
On a Slightly Curved Surface - radius
greater than 10 metres (33 ft)
On a Very Curved Surface Between
10m (33 ft) and 1m (3 ft 3") radius
Note If replacing the support ring with the blue or red rings; ensure that the ring is
���������������������
Fig. 9
In Front of
the Bulkhead
Fig. 7
Please allow a
minimum width of
250 mm (10") for
hose stowage
Fig. 8
In Front of
the Bulkhead
Use black ring attached to Angled Housing
Use the blue support ring
Use the red support ring
Fig. 10
In Front of
the Bulkhead
Recommended minimum width
allowance 350mm (14")
Recommended
minimum
height
allowance
700mm (28")
6
Advertisement
Table of Contents
