Table of Contents
Advertisement
INDUSTRIAL TRIPLEX PUMPS
INSTRUCTION MANUAL
Model
Max PSI
10.0 GA13
3800
(530003)
9.4 GA13
4000
(530004)
IMPORTANT: Please make certain that the person who is to use this equipment carefully
reads and understands these instructions before operating.
SAVE THIS MANUAL FOR FUTURE REFERENCE
Max GPM
3.5
3.3
Industrial Triplex Pumps
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for AAA 10.0 GA13
Summary of Contents for AAA 10.0 GA13
- Page 1 Industrial Triplex Pumps INDUSTRIAL TRIPLEX PUMPS INSTRUCTION MANUAL Model Max PSI Max GPM 10.0 GA13 3800 (530003) 9.4 GA13 4000 (530004) IMPORTANT: Please make certain that the person who is to use this equipment carefully reads and understands these instructions before operating.
- Page 2 INSTRUCTION MANUAL Industrial Triplex Pumps INDUSTRIAL TRIPLEX PUMPS GENERAL SAFETY INFORMATION State of California to cause cancer, birth defects or other reproductive harm. Please read and save these instructions. Wash hands after handling. Read carefully before attempting to assemble, install, operate or maintain WARNING: Adequate protective the product described.
- Page 3 INSTRUCTION MANUAL Industrial Triplex Pumps INDUSTRIAL TRIPLEX PUMPS Do not let the pressure washer run clean water through chemical injection system to rinse system for more than two minutes in Bypass thoroughly. If chemicals remain in Mode. Turn off the engine and relieve the pump, it could be damaged.
- Page 4 INSTRUCTION MANUAL Industrial Triplex Pumps INDUSTRIAL TRIPLEX PUMPS Refill pump using SIMPSON Screw bottle valve back onto ® Premium Pump Crankcase Oil. If bottle. this oil is not available, an SAE Attach bottle to water inlet of 15W-40 oil may be used. pump.
- Page 5 INSTRUCTION MANUAL Industrial Triplex Pumps INDUSTRIAL TRIPLEX PUMPS merchantability or fitness for a particular The manufacturer will not be liable to any purpose and all such warranties are persons for consequential damage, for hereby disclaimed and excluded by personal injury, or for commercial loss. the manufacturer.
- Page 6 INSTRUCTION MANUAL Industrial Triplex Pumps INDUSTRIAL TRIPLEX PUMPS TROUBLESHOOTING GUIDE Symptom Possible Cause(s) Corrective Action Oil leak between Worn rod oil seals Replace crankcase piston rod seals crankcase and pumping section Frequent or Cracked, damaged Replace plungers premature failure or worn plunger of the packing) Overpressure to Reduce inlet pressure...
Need help?
Do you have a question about the 10.0 GA13 and is the answer not in the manual?
Questions and answers