Sibata 080130-042 Operation Manual

CODE 080130-042
Particle Size Separator for
Round Filter
OPERATION MANUAL
Thank you for purchasing this product.
This operation manual describes precautions that are
important for preventing accidents as well as the
procedures used to handle the product.
To ensure safety, read this operation manual and the
attached warranty thoroughly before use, and use the
product correctly.
After reading this operation manual and the warranty,
keep them in a safe place where they can be referred
to at any time.
１ Product Overview
080130-045
The particle size separator uses the inertial impaction method to differentiate particle sizes into large and small size and sample
080130-047
them. Large particle size is sampled on a filter with slits and small size particle are sampled on a backup filter. This particle size
separator is attached to SIBATA High Volume Air Sampler, Model HV-500F and HV-500R which used φ110mm round filter.
Each Characteristic of Size Classification as follow:
080130-042 SPM Particle size separator for rectangular filter ･･･････････10μm and more 100％ cut
080130-045 PM10 Particle size separator for rectangular filter ･･････････10μm 50％ cut
080130-047 PM2.5 Particle size separator for rectangular filter ･････････2.5μm 50％ cut
２ Name and Composition of Parts
３ Assembling of particle Size Separator
Set the filter with slit between the base unit and separator and tighten a nut with knurling after put in a washer.
１
２
３
４
５
６
① Nut with knurling･･･････････････････２ pcs.
② Washer ････････････････････････････２ pcs.
③ Separator･･････････････････････････１ unit
④ Filter with slit ･･････････････････････10 sheets
⑤ Base unit ･･････････････････････････１ unit
⑥ PTFE packing ･･････････････････････１ pc.