Page 1
USER MANUAL ENGLISH EDGE EUA-1 Product code: D1486 Highlite International B.V. – Vestastraat 2 – 6468 EX – Kerkrade – the Netherlands...
Page 2
EDGE EUA-1 Preface Thank you for purchasing this DAP product. The purpose of this user manual is to provide instructions for the correct and safe use of this product. Keep the user manual for future reference as it is an integral part of the product. The user manual shall be stored at an easily accessible location.
EDGE EUA-1 Table of contents Introduction ................................3 Before Using the Product ..........................3 Intended Use ............................... 3 Text Conventions ..............................3 Symbols and Signal Words ..........................4 Safety ..................................4 Warnings and Safety Instructions ........................4 Requirements for the User ..........................5 Description of the Device ...........................
After unpacking, check the contents of the box. If any parts are missing or damaged, contact your Highlite International dealer. Your shipment includes: ● DAP EDGE EUA-1 ● 2 x BNC antenna cable (3 m) ● User manual Fig.
EDGE EUA-1 Symbols and Signal Words Safety notes and warnings are indicated throughout the user manual by safety signs. Always follow the instructions provided in this user manual. Indicates an imminently hazardous situation which, if not avoided, will result in DANGER death or serious injury.
EDGE EUA-1 Attention This device shall be used only for the purposes it is designed for. This device is intended for use as an unidirectional antenna. It is suitable for indoor use. It is not suitable for households. Any incorrect use may lead to hazardous situations and result in injuries and material damage.
Description of the Device The DAP EDGE EUA-1 is a set of 2 unidirectional antennas. The device is designed to be used with the DAP EDGE receivers but it is also suitable for other receivers that operate in the frequency range of 470–980 MHz.
EDGE EUA-1 3.3. Accessories The device is delivered without the receiver. The receiver is available in each of the following 4 sets: ● D1475B (EDGE EHS-1, 1-channel wireless handheld system) ● D1476B (EDGE EBS-1, 1-channel wireless bodypack system) ● D1479B (EDGE EHS-2, 2-channel wireless handheld system) ●...
EDGE EUA-1 Installation Ambient Conditions ● The device can be used indoors. ● The maximum ambient temperature t = 50 °C must never be exceeded. ● The relative humidity must not exceed 50 % with an ambient temperature of 50 °C.
EDGE EUA-1 Setup Safety Instructions for Operation Attention This device must be used only for the purposes it is designed for. This device is intended for use as an unidirectional antenna. It is suitable for indoor use. It is not suitable for households.
EDGE EUA-1 Connecting the Device Use the supplied antenna cables to connect the BNC connector OUT (04) to the antenna input connector of the antenna distributor (or of the receiver). The antennas receive the signal from the transmitter(s) and send it to the antenna distributor. The antenna distributor sends the signal to each connected receiver.
EDGE EUA-1 Troubleshooting This troubleshooting guide contains solutions to problems which can be carried out by an ordinary person. The device does not contain user-serviceable parts. Unauthorized modifications to the device will render the warranty void. Such modifications may result in injuries and material damage.
Approval Hereby, Highlite International declares that the device EDGE EUA-1, product code D1486, is in compliance with Directive 2014/53/EU (RED – Radio Equipment Directive). The full text of the EU declaration of conformity is available at the respective product page on the website of Highlite International (www.highlite.com).