Table of Contents
Advertisement
Quick Links
P-SET ELECTRONIC
PRESET CONTROL HANDLE
Thoroughly read and understand this manual before
installing, operating or servicing this equipment.
OPERATION, INSTALLATION,
MAINTENANCE AND REPAIR GUIDE
SERVICE BULLETIN SB3021
Model 3331-014
(with Semi-Automatic Tip)
Model 3331-020
(with Flex Extension &
Semi-Automatic Tip)
Model 3331-012
(Bare)
Rev. H 10/08
®
Advertisement
Table of Contents
Related Manuals for Balcrank 3331-014
Summary of Contents for Balcrank 3331-014
- Page 1 SERVICE BULLETIN SB3021 Rev. H 10/08 ® P-SET ELECTRONIC PRESET CONTROL HANDLE Model 3331-014 (with Semi-Automatic Tip) Model 3331-020 (with Flex Extension & Semi-Automatic Tip) Model 3331-012 (Bare) Thoroughly read and understand this manual before installing, operating or servicing this equipment.
-
Page 2: General Safety
If you require yourself and others. 3) Open dispensing valve until further assistance please contact your local pressure is relieved. Balcrank distributor or Balcrank authorized ® ® service center. WARNING A manual tip cannot be used on P-Set control handle. -
Page 3: Specifications
Specifications Accuracy: + - 0.5% (of Reading) Flow Range: 0.26 – 8 gal/min Maximum Operating Pressure: 1,500 PSI Weight: 2.55 lbs Inlet: ½” NPT Outlet: 3/8” NPT (prior to 6/03) 3/8” NPS (after 6/03) Operating Temperature: – 122 Wetted Parts: Aluminium, Acetal, Steel, Nitrile Rubber Fluid Compatibility: Engine Oil, Diesel Oil, Automatic Transmission Fluid,... -
Page 4: Options Settings
Operation of Buttons Changing Units The control buttons can be used in two ways Press and hold the reset button until “units” appears. Press: Press & release the button. Press the reset button to cycle through the units of Double click: Press & release the button twice measure. -
Page 5: Maintenance
Handle Disassembly Pressing cal cycles through options Use a clean work area to carry out maintenance. Pressing reset cycles through values for each option A) Remove the fluid hose from the control handle Pressing and holding reset 5 seconds saves the set- inlet swivel (31). -
Page 6: Field Calibration
Meter Reassembly Field Calibration A) Clean and inspect all parts. Replace any suspect, Field calibration allows a +_5% adjustment of worn, or damaged components. the calibration. B) Replace rotors (13). In Options mode press cal 5 seconds. Current Note: Ensure the rotor with the magnets is field calibration factor will be displayed 95-105 assembled with the magnets facing up and To reset the factor to 100... - Page 7 P-Set Electronic Preset Control Handle Parts List Item Part No. Qty. In Kit Description Item Part No. Qty. In Kit Description 830727 Boot, P-Set Latch Plate Assembly 830726 Module, P-Set Latch Pivot Pin Screws Spring Latch Release Assembly Plunger Battery Cover Screw Seal O-Ring Valve Body...
- Page 8 All Balcrank equipment sold by authorized Balcrank distributors is warranted to their original customer to be free from defects in materials and workmanship for a period of one year from the date of sale to that customer. Selected Balcrank equipment carries warranty terms for a more extended period as defined in the Balcrank Lubrication Equipment &...