Advertisement
temperature measurement
Mounting instructions !!!
mechanical installation
- Only use promesstec welding sleeves and process connections for the adaptation in your
process. Only by this we can guarantee you an optimal measuring point.
- After installing the sensor, check the tightness of the measuring point.
- When laying the cable, pay attention to the maximum permissible temperature range of
the cable.
electrical mounting
- Install the sensor in your process before electrical installation. In this way you avoid
winding up the cable when installing the measuring point.
- The electrical installation must be carried out in a voltage-free state.
- Connect your sensor to your evaluation electronics in accordance with the specified circuit.
Important information !!!
return and repair
The promesstec sensor have a modular design. This allows us to repair and overhaul
defective devices. To do this, send the device to promesstec. You will find a return form
with the information to be provided on our homepage under „technical information".
disposal of the devices
Dispose of devices, components and packaging in an environmentally friendly manner
in accordance with the waste treatment and disposal regulations typical for the country.
Pay attention to waste separation and the recycling of high-quality materials such as
stainless steel, etc.
further documentation
You can find these quick start guide and the data sheets as a file on our homepage under
the respective devices. The documentation is available in German and in English. Other
languages on request. Additional information such as characteristic curves of temperature
sensors etc. can be found on our homepage at
promesstec GmbH * Niedersachsenstraße 4 * 48465 Schüttorf * Tel.:+49 (0)5923/ 90229-0 * Fax +49 (0)5923/ 90229-29 * E-Mail: office@promesstec.com * Internet: www.promesstec.com
version 2.1.1 page 4/4
Advertisement
