HAMPTON BAY EC707WH Use And Care Manual

TOOLS REQUIRED
Phillips screwdriver
Installation
□
Before installing, disconnect power by turning off the circuit breaker
or removing the fuse from the fuse box.
□
Determine the ground side of the track (has indented groove on face
and two internal copper bars) and connector (side of connector with
two metal tabs). Can only be assembled if grounds are aligned.
This is not a grounded accessory.
CAUTION: NEVER PLUG INTO ELECTRICAL RECEPTACLE
UNLESS TRACK IS ATTACHED AND ASSEMBLY INSTALLED.
Loosen the set screw on the dead end cap at the appropriate track
□
end and remove. Loosen the set screw on the connector.
□
Aligning the ground sides of the track and connector, push the
connector into the open end of the track. Tighten the set screws.
□
Place the track/connector assembly at the desired location on the
ceiling, noting the location of the nearest electrical receptacle.
Mark the track holds and proceed with the installation as described
in the track instructions.
□
Insert the plug into the switch and the switch into the electrical
receptacle.
Safety Information
Permits track to be plugged into standard wall outlet where permanent installation is not convenient.
Track Lighting Plug-IN Live End Connector. Energizes track section utilizing a household electrical receptacle.
For use with Hampton Bay EC series track system. 60Hz 120V
Troubleshooting
Problem
The light bulb will not illuminate.
The fuse blows or the circuit breaker trips when
the light bulb is illuminated.
Care and Cleaning
□
Before attempting to clean, disconnect the power by unplugging the unit.
□
To clean the unit use a dry or slightly dampened clean cloth.
□
Do not use any cleaners with chemicals, solvents or harsh abrasives as damage to unit may occur.
CAUTION: Do not use chemical solvents, or harsh abrasives to clean the unit as damage to the unit
or various components may occur rendering the unit inoperable.
Warranty
The manufacturer warrants this lighting xture against defects in materials and workmanship for a period of one year from the date of purchase. If within
this period the product is found to be defective in material or workmanship, the product must be returned, with a copy of the bill of sale as proof of
purchase, to the original place of purchase. The manufacturer will, at its option, repair, replace, or refund the purchase price to the original purchaser or
consumer. This warranty does not cover light bulbs or the xture becoming damaged due to misuse, accidental damage, improper handling and/or
installation, and speci cally excludes liability for direct, incidental, or consequential damages. As some states do not allow exclusions or limitations on an
implied warranty, so the above exclusions and limitations may not apply. This warranty gives you speci c rights and you may also have other rights that
vary from state to state.
Contact the Customer Service Team at 1-855-HD-HAMPTON or visit www.hamptonbay.com.
END CONNECTOR WITH CORD AND SWITCH
Possible Cause
The light bulb is burned out.
The power is off.
There is a faulty wire connection.
There is a faulty switch.
There are crossed wires, or the power
wire is not properly grounded.
Use and Care Guide
GROUND GROOVE SIDE
GROUND CONNECTOR
TAB ON THIS SIDE
ELECTRIC CORD & PLUG
Solution
Replace the light bulb.
Make sure the power supply is on.
Check the wiring. Contact a qualied and licensed
electrician if you are not comfortable troubleshooting
wiring problems.
Test or replace the switch.
Check the wire connections.
Please contact 1-855-HD-HAMPTON for further assistance.
Item # 1004612880(804919)
Model #EC707WH
TRACK
SET SCREW
ON/OFF SWITCH
HAMPTONBAY.COM