Advertisement
MEMOREX MKA352 OSCILLATING PARTY LIGHT
TO OPERATE
Plug the unit into an electric outlet and turn the on/off button to
the on position.
SAFETY NOTE: To reduce the risk of electric shock, this furnishing has a
polarized plug (one blade is wider than the other). This plug will fit in a
polarized outlet only one way. If the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit, contact a qualified electrician to
install the proper outlet. Do not change the plug in any way.
REPLACING THE BULB
1. Turn off the power by setting the on/off button to the off position.
2. Carefully remove the screws on the sides of the unit and remove the
cover (fig. 1).
3. Make sure the burnt bulb has cooled. Hold the bulb between the
thumb and the forefinger and turn counterclockwise to remove (fig. 2).
4. Replace with a new bulb adhering to the specifications listed below.
Turn the bulb clockwise into the lamp holder (fig. 3). Turn the unit on
to make sure the new bulb is working. Dispose of the burnt bulb
properly.
5. Put the cover back on the unit and line up the screw holes. Secure the
cover on with the screws, being carefully not to over tighten them (fig.4).
SAFETY NOTES:
1. Bulb specifications: 110v~60Hz AC; Maximum 25W E12
2. For indoor use only.
3. Keep out of reach of children and pets.
4. Not for professional use.
5. Power the unit off before replacing the bulb or when not in use.
6. Any servicing is to be performed by an authorized service
representative.
7. Avoid any undue strain or stress on the product's conductors,
connections and wires while in use.
8. When not in use, store the whole product with cord into the original
packing in a cool, dry location protected from sunlight
MKA352
Advertisement
