Table of Contents
Advertisement
www.ICELED.co.uk
Custom Installation Functions
As supplied, the Factory Default settings are suited to the standard UFO kit and may
require no further adjustments, in which case the Custom sections of this guide may
be skipped entirely. However, as UFO may be used in a wide variety of applications,
a menu of options can be accessed to allow the controller to be customised for
different types of installation. A sub-menu of ICELED tube layout options is also
provided for non-standard tube lengths.
In order to select one or more of the required functions listed in the table below, the
controller must first be switched-on with a four-second long press of the power
button on the remote control handset.
After the initial unit switch-on, the power button must be kept pressed until the
remote display flashes
number to be entered on the numeric keypad. Once >
the power button can be released and the controller waits for any of the following
number button presses to select the desired function:
Option
Factory defaults
UFO state after
Power-up
Door activation
circuit D
Automatic
Power-saving
Strobe Program
in Demo mode
Tube Layout
†
Power-up refers to the connection of a nominal 12V supply to the controller. In a domestic
installation, where the controller is powered from a 12VDC transformer, switched by a lighting circuit, it
may be desirable to have the controller automatically resume the last Pattern selected rather than wait
for remote control.
On pressing any of the numbered function buttons listed in the table above, the
controller briefly displays the number entered e.g.
flashing>
The
button switches to the Layout sub-menu described in the next section.
To finally execute and store any selection
the power key must be pressed to confirm the operation. The controller will then
reset and return to standby mode.
EXIT
To abandon the selection
button. In this case the controller ignores the selection and restarts in exactly the
same state as it was before.
DEMO
(!) Restoring the Factory Defaults overwrites all Pattern colours and settings with
the factory defaults shipped with the controller - so please use with extreme caution.
indicating that the controller is ready for a function
Button
0
Restore (!)
1
Standby mode
†
2
Last mode in use
3
Active low
4
Active high
5
Disabled
6
Enabled
7
Exclude
8
Include
Enter Layout sub-menu
< symbol in readiness for any further Functions to be entered.
UFO GUIDE v8
Function
made from the option menu(s),
without making any changes at all, press the
< is flashing on the display,
Default
Typical application
Re-installation
Vehicle installation
✓
Domestic installation
Switched to ground
✓
Switched to +12V
Vehicle installation
✓
Domestic installation
Public use
✓
Private use
Non-standard tubes
before returning to the
EXIT
9
Advertisement
Table of Contents
