Chapter 8 Network Settings; Wake-On-Lan; Snmp - Buffalo LinkStation 700 Series User Manual

Chapter 8 Network Settings

Chapter 8 Network Settings

Wake-on-LAN

The LinkStation supports Wake-on-LAN, which allows it to be turned on remotely. The LinkStation will be turned on
automatically when receiving a Wake-on-LAN packet in the following situations: the LinkStation turns off but the
power switch left in the "On" position, the LinkStation enters sleep mode.
1
From Settings, click Network.
2
Click the settings icon (
3
Click Edit.
4
Enable "Wake-on-LAN", then click OK.
Wake-on-LAN is now enabled. As long as the LinkStation is connected to a power source and the network, you can
turn it on remotely.
Notes:
• After receiving the Wake-on-LAN packet, the LinkStation may take up to five minutes to be ready to use.
• To use Wake-on-LAN, you'll need Wake-on-LAN software that sends Wake-on-LAN packets. The LinkStation does
not include Wake-on-LAN software.

SNMP

If SNMP is enabled, you can browse your LinkStation from SNMP-compatible network management software.
1
From Settings, click Network.
) to the right of "IP Address".
159