Related Manuals for Encore DSC-020
Summary of Contents for Encore DSC-020
-
Page 1: Table Of Contents
Operating Manual: DSC-020 & DSC-220 Diamond Short-Cut Tabletop Squeegee Sharpener Table of Contents: Page Wheel Care Instructions Installation and Setup Machine Operation Safety Instructions Machine Controls (electrical) Machine Controls (mechanical) Setup Instructions Operating Instructions Operating Recommendations Troubleshooting Quality Problems Maintenance... - Page 2 1. If a heavy residue appears on the wheel, clean the wheel immediately with Encore cleaning sticks (furnished with your unit and may be purchased from Encore). With a good quality squeegee, the diamond wheel should be free of heavy deposits.
-
Page 3: Installation And Setup
Installation and Setup Instructions: When your machine is delivered, inspect it carefully to be certain there was no damage during shipment. If the machine is damaged, notify your carrier and Encore Engineering to file the appropriate insurance claims Remove the machine from the box. Note: the unit can be lifted by two people and may be held at any point except the aluminum guide rails on which the grinding assembly slides. -
Page 4: Machine Operation
Dial Gauge Assembly: Figure 2 1. Remove dial gauge from styrofoam container. 2. Remove bolt and wing nut from the bracket on the slide assembly on the machine. 3. Attach the dial gauge to the middle of the bracket with the bolt and wing nut. (Note: Use a hex wrench to turn the bolt while holding the wing nut stationary.) The tip of the plunger should rest against the safety shield (see... -
Page 5: Machine Controls (Mechanical)
Motor Power Switch: (Figure 3) Function; provides electricity to the grinding motor. This switch is turned on only during sharpening. Turn this switch off when machine is not in use. Machine Controls (mechanical): Figure Slide Handle: (Figure 3) Function; allows operator to move the grinding wheel back and forth during operation. -
Page 6: Operating Instructions
1. Position the wheel on the motor shaft with the set screw at the bottom and facing the flat side of the shaft (Figure 5). 2. Center the wheel on the squeegee. If you are using a profiled wheel (rather than a square-edge wheel), this centering is even more important. -
Page 7: Troubleshooting
4. When you are satisfied with the quality of the blade's edge, STOP THE SHARPENING PROCESS ON THE RIGHT SIDE of the machine. (Remember, the blade is "sharpened" only during the left to right motion.) 5. IMPORTANT: Except for emergencies, DO NOT stop moving the wheel when it is in contact with the squeegee. -
Page 8: Carriage Assembly
USE CAUTION: Keep hands away from the rotating wheel and allow only the rubber to touch the wheel. Note: Replacement cleaning blocks are available from Encore - see Spare Parts List. Carriage Assembly Maintenance: The carriage assembly moves on nylon slides. These slides are preset for proper tension to eliminate up-and-down and side-to-side move- ment of the base plate. -
Page 9: Operations Summary
Phase: Frequency: 50/60hz Maximum sharpening length: 51cm (20”) Standard Diamond Wheels: 120 grit Figure Operations Summary Squeegee Setup: 1. Make sure the grinder motor switch is in the OFF position. Move the slide assembly to the middle of the machine. 2. - Page 10 If the spinning wheel stops at any point along the squeegee, "dent" will result at the point of prolonged contact. Spare Parts List for DSC-020 The following spare parts are available for the machine you purchased. If you must replace any of these parts during the warranty period (1 year from date of purchase), we will send you a replacement free of charge.
- Page 11 DSCINCE….11...