Installation - Memorex MC1886 User Manual

CAUTION:
TO PREVENT ELECTRIC SHOCK, MATCH
THE WIDE BLADE OF THE PLUG TO THE
WIDE SLOT, FULLY INSERT.
Unravel the AC cord and connect it to a
conveniently located AC outlet having 120V
and 60Hz only. The Clock Display will
illuminate and "12:00" will blink in the window.
NOTE: If the AC plug does not fit into a nonpolarized outlet, do not file or cut the
wide blade.
If the AC cord is disconnected or if there is a power failure, this electronic clock is
designed to continue operating internally (without showing the time on the Clock
Display) with a 9 volt battery (not included). To install the battery, remove the
battery compartment cover by pressing in on the tab, then connect the battery to
the terminals of the battery snap inside the
compartment (use of an alkaline battery is
recommended). Replace the battery compartment
cover.
Be sure to check the condition of the battery
periodically by disconnecting the AC cord and
connecting it again 2 or 3 minutes later. The preset
times should continue operating. If the present time
does not appear, it indicates the battery is dead or not connected properly.
Follow these precautions when using a battery in this device:
1. Use only the size and type of battery specified.
2. Be sure to follow the correct polarity when installing the battery as indicated in the
battery compartment. Reversed batteries may cause damage to the device.
3. If the device is not to be used for a long period of time, remove the battery to prevent
damage or injury from possible battery leakage.
4. Do not try to recharge batteries not intended to be recharged; they can overheat and
rupture. (Follow battery manufacturer's directions.)

INSTALLATION

BATTERY PRECAUTIONS
5
AC Outlet
AC Plug