Jeld-Wen JII112 Steel Installation Instructions

thank you for selecting JelD-Wen products. Verify that all parts
of the shelf kit are present and undamaged before installation.
safety anD hanDling
• Read and fully understand ALL manufacturers' instructions before
beginning.
• Wear protective gear (e.g. safety glasses, gloves, etc.).
• For proper adhesion, only apply to the door when conditions are dry
o
and at least 50 F. Move the door into favorable conditions if necessary.
if inJury occurs, iMMeDiately seeK MeDical attention!
Kit incluDes
One shelf (with adhesive tape pre-installed)
neeDeD tools anD Materials
• Padded flat surface (optional)
• Tape measure
• Pencil
For best results, finish door and shelf prior to installation (if not already
finished) according to JELD-WEN finishing instructions found at www.
jeld-wen.com. If applying the shelf to a door that is already finished,
verify the finish is in good condition before applying shelf. Re-finish the
door if necessary.
prepare surface
1. The shelf can be installed on the door with the door either vertical
or horizontal. Installation may be easiest if the door is layed on a flat
padded work surface with exterior side facing up.
2. Clean the entire surface as shown in the image to the right where the
shelf will be installed. Use a clean towel and a 50% Isopropyl alcohol,
50% water solution and let dry.
position shelf
Center shelf vertically and horizontally on the cleaned surface and
lightly trace each corner of shelf on the door.
apply shelf
1. Remove the backing paper from the pre-installed adhesive tape.
Once the tape adheres to the door, it cannot be moved. Make sure
it is in the correct position before making contact with the door
surface.
2. Align the shelf with the marks on the door and press the shelf firmly
into place and hold for 15 seconds. Do not disturb for 72 hours.
note! the shelf is decorative only and not designed to support weight.
please visit jeld-wen.com for finishing instructions, warranty and care and maintenance information.
©2013 JELD-WEN, inc.; This publication and its contents are owned by JELD-WEN, inc. and are protected under the U.S. Copyright Act and other intellectual
property laws. All trademarks, service marks, logos and the like (whether registered or unregistered) are owned or controlled by JELD-WEN, inc. or others.
Unauthorized use or duplication of JELD-WEN intellectual property is prohibited.
JELD-WEN reserves the right to change product specifications without notice. Please check our website, jeld-wen.com, for current information.
installation instructions
for the Craftsman Shelf on Exterior Doors (JII112 Steel)
• Finishing supplies
• Clean towels
• Isopropyl alcohol
thank you for choosing
Panel or glass
Shelf
Panel
Panel
(01/13)