SZKTDZ KT-LCD10H User Manual

KT-LCD10H E-Bike Display User Manual
Dear customer, please read this manual before you use KT-LCD10H Display. The manual will guide you use the
instrument correctly to achieve a variety of vehicle control and vehicle status displays.

Functions and Display

Instruments using the structure form of instrument body portion and the operation buttons are
designed separately.
1 UP Button
2 SW Button
3 DOWN Button
4 Battery capacity indicator
℃
Environment temperature
5
℉
Environment fahrenheit
6 MOT Power display
7 Km/H Riding speed(metric)
8 6Km/H push power assist
TM Single trip time
9
TTM Total trip time

Operation

1. ON/OFF
Hold button long to turn on the power, and hold
the power. When the motor stops driving and when the e-bike is not used for a consecutive 5
minutes, it will automatically shut down and turn off the motor power supply.
2. Display1
Hold
10 CRUISE Cruise
11 PAS Pas level
12 VOL Battery voltage
13 THROTTLE Run sign
DST Trip distance
14
ODO Total distance
15 Backlight and headlights
16 brake display
AVS Average speed
17
MXS MAX speed
long for a second time to turn off
button to start up and enter display .

2.1 Turn on backlight and headlights

Hold long to turn on backlight and headlights (the controller
should have headlight drive output function); hold
off the backlight and headlights.

2.2 Assist ratio gear (PAS) switch

Press or
power, gear 5 is for the highest power. Each startup will automatically
restore the gear shutdown last time (the user can set randomly). Gear 0 is
without booster function.

2.3 Km/H assist promotion function

Hold and
than 6Km /h. Release

2.4 Display and delete of single data

After power on for 5 seconds, hold
single trip riding time (TM) and single trip distance (DST) flash, press
button , the content of both is cleared. If failed holding the button within
5 seconds, it will automatically return the display interface after 5 seconds,
original content is preserved.
3. Display2
Press button in display 1 to enter display 2.
In the riding mode after 5 seconds, display 2 automatically returns to
display 1, and the original motor power (MOTOR W) display the output of
temperature detection signal).

4. Display 3

Press button in display 2 to enter display 3.
In the riding condition, five seconds later, a single maximum speed (MXS)
display automatically returns to the real riding speed (Km/H).
5. In display 3, press button,and the display will re-enter display 1.
6. Hold button to turn off the display and the power supply of controller.
long again to turn
to switch 0-5 file gear. Gear 1 is for the minimum
flashes, the vehicle drives at the speed not more
button, the function is invalid.
and at the same time,