4
Position the wall mount bracket over
the screw locations, using a level to
confirm accuracy. Use a Phillips-head
screwdriver or a power drill to screw
the bracket to the wall, making sure
the center notch is pointing up.
5
Using a Phillips head screwdriver,
fasten the 2 attachment screws to the
back of the soundbar, making sure
they are fully tightened.
6
Remove the protective cap from the
optical cable, then connect the power
and optical cables to the back of the
soundbar.
7
Slide the soundbar down so the
attachment screws fit into the slots on
the wall bracket.
Make sure the touch controls are
facing up and Sonos Ray is fully
seated.