Table of Contents Table of ConTenTs ...2 PaCkage ConTenTs ...3 loCaTion of ConTrols ...4 Powering Your HeadseT ...5 Charging Your Headset ... 5 Turning Your Headset On and Off ... 6 using Your HeadseT ...7 Pairing Your Headset ... 7 Adjusting the Volume ...
Package Contents The Coby Micro Headset CV-M225 is designed to be the lightest and smallest full-featured Bluetooth earpiece you can buy. Although small in profile, it uses the latest Bluetooth v2.0 chipset with digital signal processing to provide strong con- nectivity, great sound, and extended battery life.
Powering Your Headset Charging Your Headset The headset will begin charging when inserted into the charg- ing base and the base is connected to a power supply. The LED will light red when charging; when charging is complete, the LED will turn off. www.cobyusa.com Page ...
Powering Your Headset Turning Your Headset On and Off To turn your headset on: Press and hold the multi-function control for about 6 seconds. The LED will flash blue and there will be a short tone from the speaker. The headset is now in standby mode.
Using Your Headset Pairing Your Headset Pairing means creating a trusted relationship between two or more Bluetooth devices. The devices must be paired before they can communicate with each other. Pairing identification is stored for later use, and devices will recognize each other the next time they are connected.
Page 8
Using Your Headset Activate the Bluetooth search function of the cellular phone. The message “CV-M225” will appear in the phone’s display when detected. If necessary, enter the passkey “1234”. If pairing is successful, the LED of the CV-M225 will flash blue intermittently.
Using Your Headset Adjusting the Volume During a call, the volume can be increased with the volume button, which will be accompanied by a short tone. When the volume is at maximum, you will be alerted with two short tones. When reducing the volume with the volume button, there will be a short accompanying tone.
Using Your Headset Overview of Controls During Use with Cellular Phones Headset Status Standby Pairing Voice Dial Incoming Call While Talking Not every cellphone will support all of the functions above. Please consult the user’s manual of your phone for more information.
Page 11
Using Your Headset Headset Status Press Briefly Standby Volume up Pairing Volume up Voice Dial Incoming Call While Talking Volume up Not every cellphone will support all of the functions above. Please consult the user’s manual of your phone for more information.
Troubleshooting If you have a problem with this unit, please read the troubleshoot- ing guide below and check our website at www.cobyusa.com for Frequently Asked Questions (FAQs) and firmware updates. If these resources do not resolve the problem, please contact Technical Support.
Page 13
Troubleshooting There is no audio contact between the headset and another device. The headset and the receiving device have to be paired to rec- ognize each other. They also have to be within range of each other. Make sure the headset and the receiving device are no more than 10m./30ft.
Page 14
Troubleshooting Pairing is unsuccessful. If pairing has not succeeded after a few tries, you may need to reset the headset before pairing. To reset the headset: With the headset turned off, press and hold the multi-func- tion control (MFC) for about 8 seconds until the LED indicator flashes red and blue, and then press and hold the MFC again until the LED indicator light turns off.
Important Information Please read all of the following information before using the Coby CV-M225 headset. Check for any exceptions or rules due to national/local requirements or limitations concerning the use of this Bluetooth headset or any other Bluetooth device. Check the laws and regulations on the use of cellular phones and hands-free equipment in the areas where you drive.
Page 16
Important Information vehicle. Please check with the car manufacturer to ensure that the headset will not affect the electronics systems in the motor vehicle. Some medical electronic equipment may not be shielded from RF energy. Therefore, please do not use the headset near medical equipment without permission.
Guide for Safe & Effective Use Please read the following information before using the CV-M225. Safety Instructions: Never put this device beside your ear. The loudness of the speaker may dam- • age your hearing. Make sure the volume is suitable before using the headset. If the volume is too •...
Page 18
Guide for Safe & Effective Use Don’t use the device near medical equipment without permission. • Don’t use the device in places where radio equipment or wireless devices are • prohibited (e.g., in an airplane). Don’t use the device in such a place where the danger of explo- •...
Page 19
Guide for Safe & Effective Use Disposal: Don’t dispose of this device as municipal waste. Please consult the local regulations regarding worn-out electronic products. www.cobyusa.com Page 1...
Conformity Declaration FCC: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and; (2) This device must accept any interference received, including interference that may cause undesired operation.
Specifications Compliance Power Class Frequency Range Microphone Sensitivity Talk Time Standby Time Unit Dimensions Unit Weight Compatibility Specifications and features are subject to change without prior notice. www.cobyusa.com Bluetooth v 2.0 Class 2 (-6 ~ 4dB) 2.4 – 2.48GHz < 95dB max.
Page 22
Notes Page Coby Electronics Corporation...
Page 24
Coby Electronics Corporation 56-65 rust street maspeth, nY 11378 www.cobyusa.com Coby is a registered trademark of Coby electronics Corporation. bluetooth is a registered trademark of bluetooth sig, inc. Printed in China.
Need help?
Do you have a question about the COBY CV-M225 and is the answer not in the manual?
Questions and answers