Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for LJ Star LumiStar 1000
- Page 1 Metaglas ‚ LumiStar 1000 LED, 12-24V ® Mechanically Prestressed Sight Glass Installation / Operation / Maintenance Installation and Operating Instructions Manual P.O. Box 1116 Twinsburg, OH 44087 Phone: 330/405-3040 • Fax: 330/405-3070 E-mail: view@ljstar.com • Web Site: www.ljstar.com...
-
Page 2: Table Of Contents
Table of Contents 1.00 Warranty ........................2 1.10 Exceptions 1.20 Provisions 2.00 Introduction ........................2 2.10 Important Note on Application 2.20 General Operating Conditions 3.00 Mechanical Installation .....................2 3.10 Sight Glass Types and Sizes Suitable for Mounting 3.20 Mechanical Installation – USL13 3.21 Mounting using Hinged Bracket 3.22 Mounting using Flange Adapter 3.30 Mechanical Installation –... -
Page 3: Warranty
1.00 Warranty L. J. Star warrants its LumiStar1000 LED Luminaires against defects in material and workmanship for a period of eighteen months from the date of shipment. L. J. Star will, at its option, repair or replace those products that fail to perform as specified with the following exceptions. -
Page 4: Mechanical Installation
3.00 Mechanical Installation 3.10 Sight Glass Types and Sizes Suitable for Mounting - Circular weld-on sight glass fitting to DIN 28120: size DN 50 (3” view diameter) and larger - Circular ANSI bolt-on sight window: size 1” and larger - Visual flow indicators: size 1” and larger - Circular weld-neck sight glass fitting series MV: size DN 50 and larger DN50 and DN65 require flange adapter - Sanitary clamp connection series MetaClamp: size 1”... -
Page 5: Electrical Installation
4.00 Electrical Installation 4.10 Supply Requirements Voltage: 12-24V AC/DC – Regulated Power: 12W 4.11 Notes CE compliance is achieved only with use of power supply components pursuant to the EMC directive (2014/30/EU) and, if applicable, the Low Voltage Directive (2014/35/EU). Recommended - Connect supply to separate branch circuit to avoid potential interference from adjacent equipment. -
Page 6: Operation
5.00 Operation 5.10 Continuous Mode – for Indicator-Equipped Luminaire - When power is applied, the blue LED on the indicator will blink twice while the processor initializes. - The LED and luminaire will remain on while power is supplied and turn off when power is removed. -
Page 7: Maintenance
7.00 Maintenance - Keep luminaire clean and free of dust. - Inspect luminaire for damage to glass. - Inspect luminaire for inadequate sealing, shown by moisture buildup on the interior of the lens. - Do not open the luminaire to perform service. In the event of a malfunction, please contact L.