RF Elements StationBox Installation Manual

STEP 1.
Mount an antenna on the backside of part "Base" and
fix it by using 2 screws. Set the antenna either in
vertical or horizontal polarization, according to your
needs. Note: This step is not obligatory when you do
not use integrated antenna.
STEP 2.
Insert panel into the gap in the part "Base". Choice of
the panel depends on board you want to use for
installation in StationBox. The package of the
StationBox includes 4 different types of panels
dedicated for 4 different boards. Other panels can be
ordered at your supplier.
STEP 3.
Insert Spacers into appropriate holes on the part
"Base". Amount of Spacers and its location depend on
the type of board you want to install.
STEP 4.
Place the board of your
device into holes on the front side of part "Base" and
on appropriate positions considering the Spacers.
STEP 5.
Screw the board of your device by using applied screws.
Amount of the screws depends on amount of the
Spacers that are used for your board.
STEP 6.
Insert Lower part into
"Base" according to the picture.
STEP 7.
Fix the Lower part
by using 3 applied screws.
STEP 8.
Insert mounted PCB, "Base", Lower part, antenna (in
case you use integrated antenna) into Top cover.