SprintRay Pro Wash/Dry Quick Start Manual

Hello!
Congratulations!
Your new Pro Wash/Dry system is the most technologically
advanced system for cleaning 3D printed parts. Thanks to
its patented mechanical jetting system and onboard
computer, you'll be saving time, money, and resources.
But before you get started, please read through this guide
and make sure to follow all procedures outlined herein when
using Pro Wash/Dry.
1
In the Box
Pro Wash/Dry comes out of the
box with most parts pre-installed.
The hydrometers are pre-calibrated
for each chamber to float when it's
time to refresh solvent.
Onboarding Pro 55
Card Adaptor
(See Section 11)
2
Where to Set Up
Place your Pro Wash/Dry in a well-ventilated
area on a flat, level surface. Keep it away from
extreme temperatures, windows, bright light
sources, and direct sunlight.
Never set anything on top of Pro Wash/Dry.
Pro Wash/Dry Unit
Basket Wash Filter
Pre-installed (See Section 9)
(See Section 6)
Metal Cleaning
Tweezers Brush
(See Section 9) (See Section 8)
Level surface away from light and heat.
Version 3.3
Updated on 05/20/21
Pro Wash/Dry™
Quick Start Guide
Training and Support
Your Pro Wash/Dry comes with complimentary phone and
email support. If you have questions, please get in touch:
Visit support.sprintray.com
Call 800-914-8004
Email support@sprintray.com
USB Cable Power Adaptor
(See Section 12)
Drain Hose Hydrometers
Pre-installed Pre-installed
(See Section 7) (See Section 4)
Power Cable
Magnet Sticker
For Platform
(See Section 10)
B
A C