HP Enterprise FlexNetwork MSR93X Quick Start Manual
  1. Manuals
  2. Brands
  3. HP Enterprise Manuals
  4. Network Router
  5. FlexNetwork MSR93X
  6. Quick start manual

HP Enterprise FlexNetwork MSR93X Quick Start Manual

Hide thumbs
1
2
3
4
5
6
7
8
Table of Contents

Advertisement

Quick Links

Download this manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the FlexNetwork MSR93X and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for HP Enterprise FlexNetwork MSR93X

  • Page 3: Installing The Wifi Antenna

    On a dual-3G JG531A and JG531B router, the SIM1 and SIM2 slots are JG596B Support RF bands: associated with the antenna connectors on the front and rear panels, 4G: 2100/1700/700/850/1900MHz LTE respectively. 3G: 2100/1900/1700/850/900MHz UMTS/HSDPA/HSUPA/HSPA+/DC-HSPA+ 800/1900MHz CDMA Installing the WIFI Antenna 2G: 1900/1800/900/850MHz GSM/GPRS/EDGE JG665B Support RF bands: 4G: DD800/900/1800/2100/2600MHz LTE...

  • Page 4: Installing The Gps Antenna

    Installing the 4G Antenna One 4G antenna extender cable is provided with the HP JG704A router. No 4G antenna extender cable is provided with other router models. Purchase 4G When you install two 4G antennas on a JG704A router, connect one or both of antenna extender cables as required.
  • Page 5 5998-8173R...

  • Page 6: Quick Configuration Wizard

    Figure 2 Basic configuration wizard page Web Configuration Preparation Connect the PC to the GE LAN interface of the device. Assign the PC an IP address of the subnet 192.168.1.0/24 (except 192.168.1.1), for example, 192.168.1.2. Run the Web browser and enter http://192.168.1.1 in the address bar. The IP address 192.168.1.1 is the default login IP address for the device, and it is modifiable after login.

  • Page 7: Configuring Nat

    Figure 5 Complete basic configuration wizard page Click Next. On the page as shown in Figure 4, you can perform the following configurations: Modify the IP address of VLAN-interface 1. Make sure VLAN-interface 1 and the interface of the hosts or devices that connect to the GE LAN interface are on the same subnet.
  • Page 8 Figure 6 Dynamic NAT configuration page Click Add. Documentation For more information about the installation, see HP MSR Router Series Web-based Configuration Guide (V5).

Table of Contents