Wilson Electronics WPTV28E Quick Start Manual

Parts List:
(1) Top shelf with handle & 4 bosses
(1) Bottom Shelf with caster inserts
and four bosses
(1) Electrical Assembly if 'E' model
was purchased
(2) 4" Swivel casters with brake
(2) 4" swivel casters
***NOTE: Fluted legs should be placed over bosses with the fluted channels towards each other, facing in.
1. Place top shelf on firm surface, under-
side up. For WPTV28CE use fluted legs
at this time. For WPTV42CE, use straight
legs at this time. Insert legs onto leg
bosses. Press fit as much as possible with
hands. Tap firmly with rubber mallet if
necessary.
Step 4: Locate back panel and slide down
into grooves of the 2 back legs (same side as
electrical bracket on top shelf. Take the two
side panels, slide into place. Take front panel
and slide into place positioned so that the
lock will be on the left.
H. Wilson Company
Phone (800) 245-7224
Fax (800) 245-8224
WPTV42C Model Additional Parts:
(4) Straight Legs/no channels
(4) Fluted Legs w/channels
(1) Middle shelf with 8 leg bosses
(1) Cabinet Pack
WPTV42E Model Additional Parts:
(8) Straight Legs/no channels
(1) Middle shelf with 8 leg bosses
2. If making a WPTV28CE, your table has
no middle shelf, please proceed to step
4. Otherwise, postition middle shelf, un-
derside up, onto legs. Press fit as much
as possible with hands. Using rubber
mallet, firmly seat legs into shelf.
5. Position bottom shelf, underside
up, onto legs. Firmly seat shelf onto
legs using rubber mallet.
WPTV28E/ WPTV28CE
WPTV42E/ WPTV42CE
Mobile Plasma Mount
WPTV28C Model Additional Parts:
(4) Fluted Legs w/channels
(1) Middle shelf with 8 leg bosses
(1) Cabinet Pack
WPTV28E Model Additional Parts:
(4) Straight Legs/no channels
(1) Middle shelf with 8 leg bosses
3. FOR WPTV42CE ONLY - Place 161/2" fluted
legs onto leg bosses. Press fit as much as
possible with hands. Seat firmly with rubber
mallet.
6. Insert casters into caster sockets,
making sure that you have the two
locking casters in the caster sockets
on the 18" long side of the cart that
has the handle.
To attach the electrical assembly, please see
the instructions included with the assembly.