Advertisement

Available languages

Available languages

Model DT392-HUBERT
DIGITAL
ThermomeTer
-50 to +392°F/-45 to +200°C
Note: In the following instructions, names of the control
buttons are shown in CAPS. Function information that
appears on the display is shown in BOLD CAPS.

Battery InstallatIon

Battery is installed. replace battery when LCD
becomes dim or alert level declines.
1. Insert a flat head screwdriver into the slot on the
edge of the case. Twist the screwdriver to separate
the case halves.
2. Push the used battery out of the battery holder with
the screwdriver.
3. Slide new battery into holder with positive (+)
side up.
4. Snap case halves together to close.

operatIng InstructIons

1. Slide switch to oN position. Temperature appears on
the display.
2. The temperature sensor is located in the lower 0.25"
of the stem. For the most accurate results, place the
stem at least 0.5" into the food.
3. Slide switch to oFF position when finished to
conserve battery life.
DT392
Note: Clean the thermometer stem before each use.
Note for Induction Cooktops: Sometimes, the induction cooktop
magnetic field may interfere with digital thermometers. If there is
interference, briefly turn off the induction cooktop to get a digital
thermometer reading or use a dial thermometer.
Important: DO NOT LEAVE IN HOT OVEN.
DO NOT IMMERSE THERMOMETER HEAD IN WATER.
Tip: meat should be allowed to "rest" for 10 to 15 minutes after it is
removed from oven. This allows time for the meat's internal temperature
to stabilize and the juices to redistribute. This will result in a roast that is
both juicier and easier to carve.
The information in this document has been reviewed and is believed
to be accurate. However, neither the manufacturer nor its affiliates
assume any responsibility for inaccuracies, errors or omissions that may
be contained herein. In no event will the manufacturer or its affiliates be
liable for direct, indirect, special, incidental or consequential damages
arisen by using this product or resulting from any defect/omission in
this document, even if advised of the possibility of such damages.
The manufacturer and its affiliates reserve the right to make
improvements or changes to this document and the products and
services described at any time, without notice or obligation.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the DT392 and is the answer not in the manual?

Questions and answers

Summary of Contents for Hubert DT392

  • Page 1 Model DT392-HUBERT Note: Clean the thermometer stem before each use. Note for Induction Cooktops: Sometimes, the induction cooktop magnetic field may interfere with digital thermometers. If there is interference, briefly turn off the induction cooktop to get a digital thermometer reading or use a dial thermometer.
  • Page 2 3. Le détecteur de température est localize à 6,35 mm Modèle DT392-HUBERT du bas de la tige. Pour les résultats les plus précis, placez la tige au moins 12.7 mm dans la nourriture. 4. Glisser le commutateur à la position oFF (eTeINDre) une fois la cuisson est terminée...

Table of Contents