Shutting The Projector Down; Resetting All Settings - Hitachi CP-AW100N User Manual

Troubleshooting
Regarding the indicator lamps (continued)
POWER TEMP
Blinking
In
Green
Turned
for
off
approx.
3
seconds
NOTE
• When the interior portion has become overheated, for safety
purposes, the projector is automatically shut down, and the indicator lamps
may also be turned off. In such a case, disconnect the power cord, and wait at
least 45 minutes. After the projector has sufficiently cooled down, please make
confirmation of the attachment state of the lamp and lamp cover, and then turn
the power on again.

Shutting the projector down

Only when the projector can not be turned off by usual
procedure (19), please push the shutdown switch using a
pin or similar, and disconnect the power plug from the power
outlet. Before turning it on again, wait at least 10 minutes to
make the projector cool down enough.

Resetting all settings

If it is hard to correct some wrong settings, the FACTORY RESET function
of SERVICE item in OPTION menu (57) can reset all settings (except
LANGUAGE, FILTER TIME, LAMP TIME, FILTER MESSAGE, NETWORK,
STANDBY MODE, SECURITY settings, and others) to the factory default.
80
LAMP
At least 1 Power ON schedule is saved to the projector.
Please refer to "Schedule Settings" section of User's Manual
- Network Guide.
Turned
off
Description
Shutdown switch