Table of Contents
Advertisement
Note: To ensure that no scratches are formed on
5.
the matte glass plate, do not allow the underside of
the hob to come into contact with objects.
Hold the front section of the hob and tilt it upwards
at a maximum angle of 30°. Secure the hob with
the profile bar by placing it vertically on the front
burner mount.
Remove the plastic covers from the front profiles on
6.
the right and left. Ensure that the covers are not
damaged or scratched. Unscrew the screws (T20)
below these.
Remove the two screws (M4) that are uncovered
7.
when you remove the control knobs (T15).
Grip the panel with both hands and slowly pull it up-
8.
wards. Remove the panel from the fastening lugs.
Then carefully pull the panel forwards to remove it.
Ensure that the cables are not damaged and that
the connections do not come loose.
Replacing bypass nozzles
Use a flat-head screwdriver (no. 2) to unscrew the
1.
bypass nozzles. Remove the bypass nozzles.
Select the appropriate replacement bypass nozzles
2.
from the table. You can find additional information
about this in the section entitled "Technical data –
Gas" → Page 36.
Installation instructions en
33
Advertisement
Table of Contents
