Table of Contents
Advertisement
(Page 2)
Cover Stopper Installation Instruction
7.
Install the cover stopper by performing
the following procedures.
1) Check the parts of cover stopper.
Fixing
Screws
(4 mm)
Stopper
2) Insert the bracket into the hole for instal-
lation of cover stopper.
3) Hold the bracket as shown in the follow-
ing drawing.
Attention
When you dropped
the bracket off into
the hole, remove the
front cover (6 fixing
screws) to pick up the
bracket.
All manuals and user guides at all-guides.com
Cover Guide
Bracket
Bracket
Hole
Bracket
Front Cover
[Book Binder BQ-140]
4) Attach the cover guide to the bracket with
2 fixing screws.
- Installation for the cover stopper is com-
pleted.
8.
Pull up the stop button.
9.
Press the reset button.
- The clamper moves to the right and stops
at the home position (above the nipper).
10.
Open the clamper by turning the clamp
handwheel counterclockwise.
11.
Remove the book block by sliding it out
to the right.
Attention
When using this cover stopper, the cover
length is 20.25 " (514 mm) at maximum.
Point
Adjust the stopper according to the cover
length.
20.25" (514 mm)
at maximum
Stopper
Advertisement
Table of Contents
