Page 1
UsER InsTRUCTIons VERTICAL CUTTER MIXER VCM-61 / VCM-62 Made in sweden. Exclusively distributed and serviced in Australa by Roband Australia Pty Ltd. All standard Hällde products are designed to run at 220-240V per phase, 50Hz. All specifications are nominal only. All information contained in this instruction is subject to change without notice due to constant research and development.
The speed that should be used depends on as follows: unless they are given adequate instruction the type of food to be processed, its quality, or supervision. and the desired result. HALLDE • User Instructions...
1 700 rpm (60 Hz motor). any other agent containing this substance. • Do not use sharp objects for cleaning or KNIFE: HALLDE’s agitating knife with four any objects not intended for the purpose of blades (2+2) of highest quality knife steel for cleaning.
Page 4
PARTS / ASSEMBLING ASSEMBLING THE SCRAPER FIT THE SEALING RING PLUG SCRAPER HANDLE LID INCLUDING SCRAPER FIT THE PLUG KNIFE SCRAPER RING ASSEMBLING THE BOWL BOWL MACHINE BASE HALLDE • User Instructions...
Page 5
Vertical Cutter Mixer VCM-41 and Vertical Cutter Blender VCB-61 HALLDE • User Instructions...
Page 6
Vertical Cutter Mixer VCM-41 and Vertical Cutter Blender VCB-61 HALLDE • User Instructions...
Page 7
Vertical Cutter Mixer VCM-42 and Vertical Cutter Blender VCB-62 HALLDE • User Instructions...
TITLE AND DATE OF ISSUE OF STANDARD EN 12852+A1:2010 Following the provisions of Directive and Regulation: 2014/30/EU, 2014/35/EU, 2006/42/EG, 2011/65/EU, NO 10/2011. Kista 2019-01-04 PLACE AND DATE OF ISSUE Henrik Artursson Andreas Eriksson Manager Design and Engineering Quality Coordinator HALLDE • User Instructions...