Advertisement
fig.4
4.3. Get an assistant to take the weight of the table top (fig.1.4) whilst bolting it on. The Table top brackets go to the outside of the latches see
fig.4. Use M8x45 bolt, lock nut and 8x12x3 spacer through the top hole of the latch and extension tubes (8). Refer to fig.4 to note the correct
orientation of the latch and Tilt release. ensure that the Tilt mechanism engages in the latch. If it does not, loosen the bolts through the
latch and the latch stop, and adjust until the Tilt lock releases are working smoothly each side.
4.4. Fit the horizontal bar, see fig.1.5, using flat head M8x65 screws.
4.5. Fit 'T' piece extension pipes, secure with knobs screwed through the horizontal bar, see fig1.5 &1.6. Fit the rollers, see fig.1.7. Fit their
height adjusting knobs.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
iMpoRtant: No liability is accepted for incorrect use of this product.
WaRRantY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
infoRMation: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
© Jack Sealey limited
environmental protection.
Recycle unwanted materials instead of disposing of them as
waste. All tools, accessories and packaging should be sorted,
taken to a recycle centre and disposed of in a manner which
is compatible with the environment.
sole UK Distributor, sealey Group,
Kempson Way, Suffolk Business Park,
Bury St. edmunds, Suffolk,
IP32 7AR
Original Language Version
www.sealey.co.uk
01284 757500
W e b
sales@sealey.co.uk
01284 703534
email
RS16
Issue: 1 - 14/03/14
Advertisement
