modway MOD-6227 Manual

MOD-6227

Thank you for purchasing the MODWAY BED!

Before you start, here are some helpful advice:

1. We suggest you spend a short time reading through this leaflet and then follow the simple step instructions.

2. Owing to the size and weight of the bed, we recommend that it is assembled by two adults, on a carpeted or

padded area, in the room that it is intended for. Approx assembly time: 20 minutes.

3. Please do not use any tools other than those provided or recommended in these instructions.

4. Please do not throw away any of the packaging or the instruction until you have checked all the components and

hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe

environmentally friendly way.

5. Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the

components from time to time, so please save tools that have been provided.

6. Please keep all fitting out of reach of children.

Customer Service 609-256-9000 | www.modway.com

HEADBOARD

HB SUPPORT

BED FRAME

(DOES NOT INCLUDE

WITH THE PURCHASE)

1 PC

2 PCS

01 of 03

Table of Contents

Need help?

Do you have a question about the MOD-6227 and is the answer not in the manual?

Page 1 MOD-6227 Thank you for purchasing the MODWAY BED! Before you start, here are some helpful advice: 1. We suggest you spend a short time reading through this leaflet and then follow the simple step instructions. 2. Owing to the size and weight of the bed, we recommend that it is assembled by two adults, on a carpeted or padded area, in the room that it is intended for.
Page 2 1.2 Secure each HB support stand by using 2x JCBC Bolt [1] and 2x M6 Spring Washer [2] and 2x M6 Flat Washer [3]. Tighten with supplied Allen Key [4]. Repeat the same procedure to secure the other side. Note: Hardware may loosen over time. Periodically check that all connections are tight. Customer Service 609-256-9000 | www.modway.com 02 of 03...
Page 3 3x M6 Flat Washer [3] for the thicker bed frame. Tighten with supplied Allen Key [4]. 2.3 Repeat the same procedure for each screw and each side of the bed frame. STEP 3 3.1 Assembly completed. Customer Service 609-256-9000 | www.modway.com 03 of 03...