Micron Radio Control DT Tx22 User Information

Tx22 is a hand-held wireless transmitter intended to control up to 12 model railway trains. It has controls for Speed,
Direction, Inertia, Lights and Loco selection.

Technology:

Tx22 uses the 2.4GHz band which requires no frequency channel control and is very resilient against
•
interference.
Any number of receivers can be bound to your Tx22 but a maximum of 12 can be switched on at a time to
•
operate them independently. Tx22 can select one of the 'active' receivers to operate it in a form of 'cab control'.
Range is suitable for indoors and small outdoor sites.
•
Tx22 is compatible with all DSM2 receivers. This includes all DT receivers.
•
Knob and switch positions are transmitted as separate 'channels' (1-7) which must match those used in
•
receivers.

Battery:

Tx22 uses a PP3 9V battery.
•
Remove the 4 screws holding the back of the case to insert or replace the battery.
•
There are some bare wires inside so care needs to be taken when installing the battery to avoid short circuits.
•
Make sure that the power on/off button is off (up) before) adding a removing a battery.
•
• The connector will only clip onto the battery one w

On / Off Push Button:

Tx22 has an illuminated push-button on/off switch. It is best to switch the transmitter on before the receiver.
•
The LED flickers slightly while an Inertia transition is in progress.
•
The LED flashes more boldly when Binding.
•

Speed / Throttle Knob:

300° rotary control with 'center click'.
•
Full rotation is either 'low off' 0-100% motor control or 'center off' (depends on receiver setup).
•
The Speed knob controls transmitter channel 1 and channel 6.
•
DT Tx22User Information
DT Tx22 Transmitter
User Information
ay.
info@micronradiocontrol.co.uk