Summary of Contents for NCR MSR
- Page 1 Kit Instructions Magnetic Stripe Reader (MSR) for 18.5" 5968 Display 5968-K144 Issue A...
-
Page 2: Revision Record
NCR, therefore, reserves the right to change specifications without prior notice. All features, functions, and operations described herein may not be marketed by NCR in all parts of the world. In some instances, photographs are of equipment prototypes. Therefore, before using this document, consult with your NCR representative or NCR office for information that is applicable and current. -
Page 3: Kit Contents
MSR for 18.5" 5968 Display This kit provides a Magnetic Stripe Reader (MSR) for the 18.5" 5968 RealPOS X-Series Display. Kit Contents... -
Page 4: Installation Procedure
MSR for 18.5" 5968 Display Installation Procedure 1. Remove the screws (2) that secure the Stand and Rear Cover to the display. Caution: Always use a soft material (cloth, foam) to protect the display screen when placing the terminal face down. - Page 5 MSR for 18.5" 5968 Display 3. Remove the Display Collar (7 screws). 4. Remove the Blank Plate from Port A of the Display Collar. The plate is connected to the Display Collar with a strong adhesive. Use care when removing it to avoid...
- Page 6 5. Mount the Magnetic Stripe Reader (MSR) on the Display Collar. a. Route the MSR Cable through the cable access of the Display Collar. b. Install the MSR on the Display Collar (2 screws included in the kit). Note: Do not overtighten the screws.
- Page 7 Connect the Extension Cable to the Motherboard. c. Tape the MSR Cable to the Display Sled between the score lines as shown below. This locates the cable so it does not get pinched when the Rear Cover is installed.