Power Connection; Hardware Installation - Vivotek AE2000 User Manual

III.

Power connection

Please refer to the wiring diagram as below.
IR Control Board
When using two-cord power cable, please connect them to "Live" and "Neutral".
External Power Input Connection
L
IV.

Hardware installation

1. Loosen two screws on both sides of the camera bracket, and then adjust the position of
camera bracket by sliding it up and down.
2. Use the supplied L-type hex key wrench to fix the camera on the camera bracket.
3. Connect the power cable and Ethernet cable to the camera.
Side View
Zoom ring
AE2000_Manual_VVTK_20080806.indd
D/N trigger signal
10
Red
Red wire: +5Vdc
Orange wire: 0Vdc
Black wire: Ground
E N
Neutral (Blue Wire)
Earth (Yellow/Green Wire)
Live (Brown Wire)
Focus ring
4
A: If IR trigger signal is on the high position
(+5Vdc), connect the Red and Black
wire to D/N trigger line +/- of camera.
Black
B: If IR trigger signal is on the Low position
(+0Vdc), connect the Orange and Black
wire to D/N trigger line +/- of camera.
Orange
L-type hex key wrench
2
4
AC 24V Adapter
1
2008/8/7 上午 10:52:2