Table of Contents
Advertisement
Quick Links
1
Take out the wood boards.
3
Assemble Halocode.
Turn the Micro USB port to
the opening of the wood
board. Put down Halocode.
4
Insert two 10cm cables into the left and right ports on the
dual color sensor.
7
Bind the two boards using a rubber band.
Combine the two boards.
2
1
Put Halocode' s
cable through the
hole as shown.
Building Instructions
Pro tips
Use the sandpaper included to
sand a smooth finish on the
wood board before you start
installing it.
Tighten the stud.
5
Assemble the power module and the dual color sensor.
Tighten the studs.
10 cm
20 cm
Attach a rubber band.
Rotate
2
Insert a 10cm cable into Halocode.
1:1
M3 *14mm
M3 *30mm
6
1
1:1
M3 *30mm
M3 *14mm
8
Assemble the wood boards using a rubber band.
Combine the two boards.
2
1
Put the dual color
sensor' s cable through
the hole as shown.
10 cm
20 cm
Follow the same steps to install
the rest screws and studs.
Add the wood board.
Put the cable
through the
hole as shown.
2
Combine the
two boards.
Rotate
Attach a rubber
band.
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Makeblock Color Picker
Summary of Contents for Makeblock Color Picker
- Page 1 Building Instructions Take out the wood boards. Insert a 10cm cable into Halocode. Pro tips Use the sandpaper included to sand a smooth finish on the 10 cm wood board before you start installing it. 20 cm Assemble Halocode. Follow the same steps to install the rest screws and studs.
- Page 2 Insert the dual color sensor cable to the speaker as shown. Add the speaker to the board. Connect the power module to the dual color sensor. Good job! You’ ve got a color picker. Now, return to mBlock on your PC or iPad and program your project.
Need help?
Do you have a question about the Color Picker and is the answer not in the manual?
Questions and answers