Advertisement
Inspection
To maintain the safety and serviceability of this product, the
following inspections must be performed:
1.
Operator Inspection
The operator shall inspect the product before and after each
use (See Pre-Use Check List). Refer any signs of deterioration
to a competent person for a decision on the safety and
serviceability of the product.
2.
Periodic Inspection
A full periodic inspection shall be conducted every twelve
months (six months in marine conditions) by an Authorised
Service Agent. Use the checklist as a guide for determining
the condition of the product. Check for any sign of
contaminants such as oil, grease, paint, etc.
WARNING: If any part of an assembly is to be exposed to chemicals,
(eg. Cleaning materials or hazardous atmospheres) the user should
consult the manufacturer to determine whether the part is suitable
for continued use.
Periodic inspections shall be recorded in the product's Inspection
and Maintenance log.
Maintenance
This product should be cleaned regularly to maintain its safety and
serviceability. Clean as indicated below.
1.
After each use wipe down the product with a soft cloth or soft brush
to remove any dust or dirt. Do not use abrasive materials to clean
the product.
2.
If the product is very dirty, carefully wash the casing with water
(maximum 50°C) using a neutral detergent. Air dry in a sheltered
position away from direct heat sources.
3.
Store the product away from direct sunlight, excessive dust and
moisture and corrosive atmospheres.
SUPPLIER
DESIGNATION
MODEL/ITEM #
SERIAL #
BATCH #
DATE
Ferno Australia | 11 Johnstone Road, Brendale QLD 4500 | +61 7 3881 4999 | INFO@FERNO.COM.AU | FERNO.COM.AU
INSPECTION & MAINTENANCE
WINCH FOR RAISING OR LOWERING PERSONNEL OR MATERIAL
APOD-WINCH20M
INSPECTION AND MAINTENANCE RECORD
NAME
Inspect before each use
PRE-USE INSPECTION CHECKLIST
ATTACHMENT POINTS
OUTER SHELL CASING
WIRE CABLE
(Wear gloves!)
FALL INDICATOR
CONNECTORS
GENERAL INSPECTION CHECK LIST
Ensure casing bolts are tight
BLOCK HOUSING
Missing parts, cracks or wear, physical damage?
Any unauthorised modifications?
Ensure no kinks, cuts, needles or broken strands,
crushed, jammed or flattened strands, signs of wire
fatigue
WIRE CABLE
Signs of rust, pitting or corrosion
(Wear Gloves!)
Signs of heat damage, torch burns, electric arc strikes
Overall deterioration, excessive outside wear
Cable extends and retracts smoothly
Distortion of hook or latch
Cracks or forging folds
Wear at swivels and latch pivot pin
SNAP HOOKS &
Open rollers
KARABINERS
Free movement of the latch over its full travel
Broken, weak or misplaced latch springs (compare if
possible with a new snap hook)
MANUFACTURE DATE
PURCHASE DATE
COMMISSIONED DATE
DETAILS
Any signs of distortion, rust or wear?
Any cracks, deformation, burns or signs of
corrosion?
Are screws and nuts in place and fully
tightened?
Is the wire in good condition?
Does the entire length of the wire extend and
retract smoothly?
Are there any signs of abrasion or damage?
Has the fall indicator been activated? If it has, do
not use and remove the product from service
Do the levers move freely?
Do the connectors lock properly?
Fall Arrest Blocks
©FERNO AUSTRALIA / 00551 DEC 2021 |
4
Page 4 of 4
Advertisement
