Section 10 - Lsz20 Install New Or Rebushed Lower Control Arm - Neway LSZ13 Repair Manual

Control Arm Installation
10. LSZ20 Install New or Rebushed
Lower Control Arm
1. Position new or re-bushed lower control arm assembly
with four (4) wear washers into axle and frame bracket.
NOTE: Make sure all four (4) wear washers are installed
onto bushings prior to lower control arm installation.
2 Install one (1) new 7/8" lower pivot bolt, one (1) new 7/8"
washer, shelf bracket and spacer wrapper at frame bracket.
3 Install one (1) 7/8" lower pivot bolt and one (1) 7/8"
washer at axle.
4 Install two (2) 7/8" lock nuts and two (2) 7/8" washers
onto two (2) lower 7/8" pivot bolts. Torque two (2) lower
7/8" pivot lock nuts to torque specified in Section 11.
5 Repeat on opposite side if needed.
6. Remove the wheel chocks from drive tires.
14 XL-PS20053RM-en-US Rev A · 2017-10-06 · Amendments and Errors Reserved © SAF-HOLLAND, Inc., SAF-HOLLAND, HOLLAND, NEWAY, SAF, and logos are trademarks of
SAF-HOLLAND S.A., SAF-HOLLAND GmbH, and SAF-HOLLAND, Inc.