Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for motogadget mo.lock NFC
- Page 1 NFC V1.3...
- Page 2 SUITABLE TO DIAGNOSE A FAILURE OR DEFECT. MOUNTING ON UNEVEN FACES WILL CRACK THE HOUSING AND CAUSE A FAILURE. Thank you very much for purchasing a high quality motogadget product - Made in Germany. Please read the following information and recommendations thoroughly and follow these in- structions during installation and use.
-
Page 3: Exclusion Of Liability
In this regard, we refer to our General Terms of Business and Delivery, which are published at www.motogadget.com. Should a return of the received delivery be agreed, please note that we only take back goods in their original packaging. The mo.lock and its accessories must be returned within the legal period of time and without any traces of use. -
Page 4: Safety Instructions
DEVICE HOUSINGS AND ALL OTHER DELIVERED PARTS MUST NOT BE OPENED OR DISMANTLED. IN CASE OF NON-COMPLIANCE, ALL WARRANTY CLAIMS BECOMES INVALID. THE USE OF THE DELIVERED DEVICE AND ITS ACCESSO- RIES FOR RACING OR OTHER COMPETITIONS AS WELL AS FOR ANY USE NOT CORRESPONDING TO THE RECOMMENDED APPLICATION ALL WARRANTY CLAIMS SHALL BE INVALID. -
Page 5: Technical Specifications
• THE DEVICE WILL BECOME DAMAGED BEYOND REPAIR IF A BATTERY CABLE IS DISCONNECTED (DUE TO LOOSE OR WORN CONTACT ETC.) WHILE THE ENGINE IS RUNNING. PLEASE MAKE SURE THAT THE VEHICLE’S BATTERY IS CONNECTED CORRECTLY AND THAT THE CONNECTOR CABLES ARE FIXED TIGHTLY. 4 Registration obligation According to the regulations of the respective country, a steering wheel lock may be required by law. - Page 6 6 Features status LED mounting screws M4 off - ignition off green - ignition on blue - teach mode yellow - over limits: voltage < 11V voltage > 15V current > 7A cbale outlet mounting screw M3 key sensitive area ignition plus Kl.15 battery ground...
-
Page 7: Mechanical Attachment
7 Mechanical attachment The mo.lock will be attached to the supplied bracket with an M3 screw. The bracket can be mounted to the vehicle using two M4 screws (10mm distance) on a fl at surface. Alternatively, the mo.lock can be attached to a self-made bracket with an M3 screw. No tensile or compressive stresses must act on the housing, otherwise the housing may break. -
Page 8: Electrical Connection
When starting large engines, high current fl ow and voltage drop in the vehicle electrical system may cause the relay to drop. In this case motogadget item no. 4002002, which is connected to relay contacts 85 and 86 solve the issue. - Page 9 wire cross-sections min. 5mm² from battery plus via 40A fuse to relay terminals 87 and 30 0.5mm² all remaining lines...
-
Page 10: How It Works
9 How it works The mo.lock works on the basis of NFC technology. The ignition lock sends electromagnetic pulses, which the key can use to send back its iden- tifi er. Therefore the key does not need an internal battery. The mo.lock penetrates electrically non-conductive material and can sofore be integrated hidden into the vehicle (e.g. - Page 11 fl ashing red during teach-in. 12 Returns and complaints Before sending a mo.lock for a check to motogadget, please contact the technical support. To do so, visit our website and follow the instructions under “Support”. To return a item, follow the instructions under “Service”...
- Page 12 A copy of the declaration of conformity can be provided on request. This equipment complies with the essential requirements of EU Directive 1999/5/EC.Hereby, motogadget declares that motogadget products and accessories are in compliance with the essential requirements and other relevant provisions of the EU Directive 1999/5/EC.
Need help?
Do you have a question about the mo.lock NFC and is the answer not in the manual?
Questions and answers