Advertisement
Assembly
1. Remove the cover ② from the base plate ①.
2. Hold the base plate ① against the wall at the desired loca-
tion and mark the four drill holes horizontally.
3. Drill holes with a diameter of 6 mm in the wall at the
marked positions.
4. Insert four masonry plugs ⑤ in the drill holes.
5. Run the speaker cable through the holes in the base plate
① from below.
②
6. Screw the base plate ① on the wall using four half round
head screws ④.
7. Run the upper end of the speaker cable through the hole
in the cover ②.
8. Put the cover ② on the base plate ①. In the process, the
speaker cable must be run through the notches on the
front and bottom side.
9. Insert the bracket ③ in the base plate ① and screw
tighten it using two screws ⑦.
If necessary, the speaker can be horizontally aligned with
the listening position later by loosening these screws.
10. If necessary, loosen the screw ⑨ and change the inclina-
tion of the bracket ③.
③
⑨
11. Attach the speaker to the bracket ③.
You have two options for this:
④
①
⑤
⑦
①
⑦
③
Speakers with key hole on the rear panel:
Insert the retaining bolt ⑧ in the bracket ③ from the front and
screw it in place loosely using the nut ⑥.
Carefully hang up the speaker on the retaining bolt ⑧ and
screw tighten it using the nut ⑥.
Speakers with M6 thread on the rear panel:
Screw tighten the speaker on the bracket ③ using the screw
⑦.
Page 3
⑥
⑧
③
⑦
③
Advertisement
