Advertisement
IN STAL L AT I O N GU I D E
I N STA LLAT I O N MANUAL
N ote: T hi s produ ct mus t b e i n sta ll ed by a li cen s ed trad es pers o n.
This is a ge n e ral in stall at i on gu i de - th ere are m any fact o r s
that a re invo lve d th at can a l t e r t he i n st all at i on meth o d.
BEFOR E YO U STA RT
This produ ct in stall mu s t c ompl y wit h t h e s ta n dards in yo u r
- Co n t act a q u a l i fi e d t rades m e n f or i n s ta l l a ti o n o f t h i s m i r ror
res pecti ve c ou n tr y an d mu st b e a dh ered to by you r li cen s ed t rades per so n .
- Co n t act a q u a l i fi e d e l e c tr ic i an f or th e w i r in g i n s ta l l a ti o n of th is m ir ror
Step 1: Find a structural member within the wall being mounted to (timber stud, concrete wall, timber block)
Step 2: Install the female brackets onto the wall spread evenly to balance the mirrors weight, screws should
be a minimum of 10 gauge to ensure shear strength, ensure that the screw is installed tightly and has
penetrated a structural material.
Step 3: Check that the brackets are installed level with eachother
Step 4: Install the male brackets onto the mirror and ensure that the location of the female and male
brackets align perfectly. Ensure you do not use screws too long when fixing the male brackets as this could
penetrate the mirror. We recommend using 12mm timber screws
Step 5: Engage a qualified electrician to wire into the driver which is located and pre-fitted into the back of
the mirror
Step 6: Once wired, it can be mounted by lifting the mirror whilst aligning the male and female brackets, this
does not require glue if brackets are installed correctly.
R eg ul a r l y cl ean w i th
m i l d l i q u i d d ete rge n t
o r s o ap a nd wa te r.
D O N OT u s e c re am
c le an e r s o r b le a ch .
Th e s e s u bs t a n c e s a re
a bras ive .
MALE BRACKETS
FEMALE BRACKETS
DO N OT u s e c l e a n i n g
pa d s wit h a b ra s i ve
s u r fa c e s a s th i s m a y
s c ra t ch t h e m a t er ia l .
Advertisement
