Connect And Disconnect The Human Interface - Focal Balancer User Manual

Connect and disconnect the Human Interface

When the user wants to fold Balancer, it is recommended that the Human Interface is
disconnected from the system.
Warning: Before disconnecting the Human Interface make sure that the user's arm
is removed from Balancer.
Warning: After connecting the Human Interface make sure that the snap hook
is well closed
To disconnect the Human Interface, make
sure that the user's arm is removed out of
the interface and follow the steps.
Make sure that the balance force is set
STEP 1:
to the minimum.
Hold with one hand the rope just
STEP 2:
above the mounting loop and with the other
hand the slide bar.
Pull the rope with mounting loop to a
STEP 3:
comfortable height.
Clip and hold open the snap hook.
STEP 4:
Lift the Human Interface in an 45°
STEP 5:
angle out of the mounting loop.
Let the rope slowly retract into the
STEP 6:
Balancer.
To connect the Human Interface, follow the
steps.
Make sure that the balance force is set
STEP 1:
to the minimum.
Hold with one hand the rope just
STEP 2:
above the mounting loop and with the other
hand the slide bar.
Pull the rope with mounting loop to a
STEP 3:
comfortable height.
Clip and hold open the snap hook.
STEP 4:
Lower the Human Interface in an 45°
STEP 5:
angle in the opening of the mounting loop.
Let the rope slowly retract into the
STEP 6:
Balancer.
16
Folding and unfolding the Balancer
The Balancer can be folded when it is not used. This provides a safe setting for the user and the
device. There are to options to fold the Balancer, only the horizontal tube for a quick folding
option or both the horizontal and vertical tubes for a more compact setting.
Warning: Before folding the Balancer make sure that the Human Interface is removed
from the system.
Warning: After folding back, the Balancer make sure that the levers are tighten firmly
however do not overtighten the levers or replace them with a nut.
To fold Balancer, make sure that Human
Interface is removed from the system and
follow the steps.
Folding horizontal bar:
Loosen the lever of the rotation link.
STEP 1:
Hold with one hand the vertical tube
STEP 2:
and with the other hand the horizontal tube.
Move the horizontal tube 90° down.
STEP 3:
Tighten the lever of the rotation link.
STEP 4:
Folding vertical bar:
Loosen the lever of the Vertical link.
STEP 1:
Hold with one hand the combination
STEP 2:
of the vertical with horizontal tube and with
the other hand the mounting tube.
Move the combination 180°
STEP 3:
backwards.
Tighten the lever of the vertical link.
STEP 4:
17