Advertisement
2. INSTALLATION
Important safety information
The air curtain must not be installed in an area where there is any possibility of water/moisture ingress. The air curtain must
be isolated from the power supply during installation and maintenance, and must be earthed in accordance with the local
regulations.
2.1
Upon receipt, the air curtain should be visually inspected to check for any damage.
2.2
Check the details on the rating plate to ensure that the correct power supply (voltage, frequency and phase) is available.
An incorrect power supply will lead to permanent damage to the air curtain.
2.3
Supply connection is via terminal block behind centre inlet grille.
2.4
Means for electrical disconnections must be incorporated in the wiring installation in accordance with the relevant wiring
and electrical regulations.
2.5
Accessories: 6 sets of bolts (M8 x 60mm), washers, spring washers, nuts.
2.6
Installation position to follow the diagram below:
2.7
Coverage height: 3.5m (To install air curtain horizontally).
2.8
Installation on concrete wall:
• Remove installation support plate from rear of unit by removing the 3 fixing screws. See following diagram.
• Use Dyna bolts or equivalent to fit the Installation Support Plate to the wall
• Install the unit body onto the Installation Support Plate (see following diagram)
Part No: INST-AIRCURTAIN
Version 1.1
09/21
Page 2/4
Advertisement
