CYCLOPS H4 Mounting Instructions

Led bulb

NEW H4/H7 LED Bulb Mounting Instructions

NOTE: Your new Cyclops LED headlight replacement bulb has a removable base to aid in installation. It is

the customers responsibility to ensure that their headlight is powered by DC power. On average,

modern motorcycles are DC powered. However, most snow machines, 2 strokes and carbureted dirt

bikes are generally AC powered. Rectifiers can be purchased from Cyclops in these cases.

1. Remove the Cyclops bulb-base from your Cyclops bulb housing.

NOTICE: Edges of the base are sharp. To remove the base, gently push down & turn

•

Hold the fan with one hand, having the bulb face you. Notice the keyway's (notches) and their

sizes. Push down on the base and twist counterclockwise with your other hand to release.

•

Slide the base up and over the top of the LED. Use caution to avoid damaging the emitters.

NOTE: Keyways are different sizes! Cyclops is not responsible for broken bases.

1 |

P a g e

For DC Use Only

counterclockwise.

Table of Contents

Need help?

Do you have a question about the H4 and is the answer not in the manual?

Page 1 NEW H4/H7 LED Bulb Mounting Instructions For DC Use Only NOTE: Your new Cyclops LED headlight replacement bulb has a removable base to aid in installation. It is the customers responsibility to ensure that their headlight is powered by DC power. On average, modern motorcycles are DC powered.
Page 2 3. Install the bulb by inserting it into the base and turning it clockwise to lock it into the base. 4. Attach the headlight housing rubber boot to your H4 bulb (not all bikes have a rubber boot). a. Some bikes will have a rubber boot on the back of the headlight reflector housing. Make sure to push-fit the boot over the Cyclops bulb base.
Page 3 The housing cover is a soft metal and can bend down against the fan and cause it to not function. DAMAGE TO THE FAN HOUSING COVER IS NOT COVERED BY THE WARANTY P a g e Thank you for your business and please contact us at 1-800-624-0278 with questions Cyclops Adventure Sports...
Page 4 6. The emitters should be facing left & right. (Not up & down) when viewed from the front as in the pictures below. 7. Check the headlight aim, it is often necessary to re-aim your headlight after bulb install. P a g e Thank you for your business and please contact us at 1-800-624-0278 with questions Cyclops Adventure Sports...